Cisco C3850-NM-4-1G Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Перемикач Cisco C3850-NM-4-1G. Cisco C3850-NM-4-1G 15 сторінок.
Також для Cisco C3850-NM-4-1G: Встановлення (17 сторінок)

Друкувати сторінку

Network Module Port Configurations

Caution

Step 4

Position the module face up to install it in the module slot. Slide the module into the slot until the screw makes

contact with the chassis. Fasten the captive screws to secure the network module in place.

Figure 1: Installing the Network Module in the Switch

Network Module Port Configurations

C9300-NM-2Q Module

If you use a 40G QSFP module, the ports default to 40G interfaces. In this case, the 10G interfaces are displayed

but not used.

Table 1: C9300-NM-2Q Module with 40G QSFP Module

Interface

FortyGigabitEthernet1/1/1

FortyGigabitEthernet1/1/2

TenGigabitEthernet1/1/1

Installing a Network Module

Verify the correct orientation of your module before installing it. Incorrect installation can damage

the module.

Do not install the network module with connected cables or installed pluggable transceivers. Always

remove any cables and transceiver modules before you install the network module.

A module interface might become error-disabled when a network module with connected fiber-optic

cables is installed or removed. If an interface is error-disabled, you can reenable the interface by

using the shutdown and no shutdown interface configuration commands.

Action

Configure this interface

Disregard

Installing a Network Module