Accustic Arts AMP I MK 2 Посібник - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник для Програвач компакт-дисків Accustic Arts AMP I MK 2. Accustic Arts AMP I MK 2 14 сторінок.
Також для Accustic Arts AMP I MK 2: Посібник (10 сторінок)

Друкувати сторінку

6.5.3 I  and I (= SKIP)

 Key I  starts the previous track

 Key I starts the next track

6.5.4 PROG (= programming function)

Use the PROG key to re-define the playback order of the CD music tracks and so create your own

individual playback sequence.The programming is made as follows:

Press the number keys for the tracks you would like to enter in your selection in the desired order. After

pressing each number key you must also press the PROG key in order to store the respective track in the

program mode. If you have stored the wrong track – a track you do not require in the selection – then

press the number of the track you wish to delete once more and confirm with the PROG key.

Example: To program the tracks 2, 3, 6, 7, 9 and 12 of a CD

First press the number key 2 and then the PROG key. In the display PROGRAM is shown and the track

2 is set as your first selected track. Now press key 3 and then PROG again. Proceed in the same way

until track 12. After track 12 is also programmed, in your display you will see the following:

22:40

This display shows clearly you have stored 6 tracks (TRACK) with a total playing (TOTAL TIME) of

exactly 22 minutes 40 seconds in this example.

When you have finished your programming, please press PLAY and playback begins. To stop the CD

press STOP once as usual, the programming remains. When STOP is pressed again your programming

is deleted, PROGRAM in the display goes away and the device once again shows the total number of

tracks and the total playing time .

6.5.5 VOLUME

Use the VOLUME key to adjust the volume of an ACCUSTIC ARTS® integrated amplifier (e.g. POWER I

or preamplifier (e.g. PREAMP I).

Please note: The DRIVE I – MK 2 itself is not equipped with a volume control.

6.6 SHIFT key: additional functions of the remote control SRC II

Use the SHIFT key to activate the following functions:

 REPEAT

 SHUFFLE

 PAUSE





(SCAN FORWARDS)

 (



SCAN BACKWARDS)

 SCAN

 TIME

 A/B

Press the SHIFT key once to activate the function and the red LED lights up on the remote control.

You now have enough time to select additional functions (REPEAT, SHUFFLE, etc.). After 10 seconds

with no key pressed the SHIFT function is automatically cancelled and the red LED goes out.

You can also end the SHIFT function at any time by pressing and holding the SHIFT key until the red

LED light goes out.