Cisco Catalyst 3012 Посібник з встановлення обладнання - Сторінка 23
Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Перемикач Cisco Catalyst 3012. Cisco Catalyst 3012 48 сторінок. Catalyst switch module for ibm bladecenter
Також для Cisco Catalyst 3012: Посібник для початківців (31 сторінок)
Друкувати сторінку
Chapter 2
Switch Module Installation
Connecting a Switch Stack
Follow these steps:
Install the member switch modules if you have not already done so.
Step 1
Remove the dust covers from the StackWise Plus cables, and store them for future use.
Step 2
Verify that cables are aligned as shown in
Step 3
Figure 2-3
Step 4
Insert the cable into the StackWise Plus port on the front panel of the switch module. Insert the other end
of the cable into the connector of the other switch module.
Always use a Cisco-approved StackWise Plus cable to connect the switch modules.
Caution
Configure the member switch modules through the master switch module by using the CLI through the
Step 5
console port of any stack member.
To remove the StackWise Plus cables, grasp the tab on the cable connector, and gently pull straight out.
When you remove the StackWise Plus cables, replace the dust covers to protect them from dust.
Removing and installing the StackWise Plus cable can shorten its useful life. Do not remove and insert
Caution
the cable more often than is absolutely necessary.
OL-12192-01
Connecting the StackWise Plus Cables
The new stack-member switch module restarts when you connect the StackWise Plus cables.
Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter Hardware Installation Guide
Figure
2-3. (The cables are keyed for correct insertion.)
C
O
N
S
O
L
M
E
O
!
D
E
M
M
B
S
R
T
LN K
15
AC T
LN K
16
AC T
LN K
17
AC T
LN K
18
AC T
1 ST AC
K 2
Creating Switch Stacks
2-7