FIBARO FGK Series Короткий посібник з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Короткий посібник з експлуатації для Аксесуари FIBARO FGK Series. FIBARO FGK Series 3 сторінки. Door/window sensor

Друкувати сторінку

First step to provide professional support and service is proper diagnose of failure. To avoid sending

fully functional devices to warranty service, please follow step by step guide below.

STEP 1. Check visually.

FIBARO Door/Window Sensor should have no scratches or cracks visible. However, if there

are any heavy mechanical damages, as smashed casing, casing bitten by a dog, warranty

will not be considered!

STEP 2. Check the battery.

To check the battery You will need voltmeter. Open the casing and touch voltmeter contacts

with battery poles. Remember to make a measurement while battery is connected. Properly

working battery should indicate voltage between 3,5 [V] up to 3,7 [V]. If You don't have any

voltmeter, please simply try to change the battery from other, efficient module.

STEP 3. Resetting FIBARO Door/Window Sensor.

The FIBARO Door/Window reset erases the EEPROM memory, including all information on

the Z-Wave network and the main controller.

Reset procedure:

-take off the sensor's cover and remove battery;

-make sure the tamper isn' t pressed;

-put the magnet near sensor;

-insert the battery;

-within 2 seconds remove the magnet from the sensor;

-after 3 seconds LED should start blinking;

-remove the battery and reinstall it again.

Successful reset should be confirmed by LED blinking.

STEP 4. Excluding and including sensor from Z-Wave Network.

Before every inclusion, sensor must be excluded from Z-Wave network. This can be done in

two ways, resetting sensor or:

-set main controller in learn mode (delete device mode);

-make sure sensors casing is closed;