Digisol DG-GS1510HPEV2 Посібник з встановлення обладнання - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Перемикач Digisol DG-GS1510HPEV2. Digisol DG-GS1510HPEV2 15 сторінок.



Read the installation instructions carefully before you connect the system to its

power source.

Notes：



 Preventing electrostatic discharge damage

Electrostatic discharge can damage equipment and impair electrical circuitry. It occurs

when electronic components are improperly handled and can result in complete or

intermittent failures.

Always follow electrostatic discharge prevention procedures when removing and

replacing components. Ensure that the chassis is electrically connected to earth ground.

Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. Connect

the clip to an unpainted surface of the chassis frame to safely channel unwanted ESD

voltages to ground.To properly guard against ESD damage and shocks,the wrist strap

and cord must be used effectively.If no wrist strap is available, ground yourself by

touching the metal part of the chassis.

 General site requirements

This section describes the requirements your site must meet for safe installation and

operation of your system. Ensure that your site is properly prepared before beginning

installation.

 Site environment

The switch can be placed on a desktop or mounted in a rack.The location of the chassis

and the layout of your equipment rack or wiring room are extremely important for proper

system operation. Placing equipment too close together, inadequate ventilation, and

inaccessible panels can make system maintenance or cause system malfunctions and

shutdown.

Look carefully for possible hazards in your working area, such as moist floors,ungrounded

power extension cable, frayed power cord.

Locate the emergency power off switch for the room in which you are working. Then, if an

electrical accident occurs, you can act quickly to turn off the power.

Power off the switch and unplug the power cord before doing the following:

Installing or removing the chassis

Working near power supply

Do not work alone if potentially hazardous condition exists.

Never assume that power is disconnected from a circuit. Always check.

If an accident occurs ,proceed as follows:

Turn OFF power to the system

Use caution

Determine if the victim needs rescue breathing or external cardiac compression; then take

appropriate action.

If possible, send another person to get medical aids. Otherwise, assess the condition of the

victim and then call for help.

Hardware Installation Guide

- 4