FIBARO FGMS-001 Посібник з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Датчики безпеки FIBARO FGMS-001. FIBARO FGMS-001 20 сторінок. Motion sensor
Також для FIBARO FGMS-001: Посібник з експлуатації (2 сторінок), Посібник з експлуатації (11 сторінок)

Друкувати сторінку

CAUTION

To make Z-Wave range

test possible, the de-

vice must be added

to the Z-Wave control-

ler. Testing may stress

the network, so it is

recommended to per-

form the test only in

special cases.

NOTE

Communication mode

of the Motion Sensor

may switch between

direct and one using

routing, especially if

the device is on the

limit of the direct

range.

Z-WAvE RAnGE TEST

#7: Z-Wave range test

The Motion Sensor has a built in Z-Wave network main controller's

range tester.

Follow the below instructions to test the main controller's range:

1. Open the cover.

2. Press and hold the B-button.

3. Wait for visual indicator to glow violet (1st menu position).

4. Release the B-button.

5. Click the B-button to confirm selection.

6. visual indicator will indicate the Z-Wave network's range (range

signalling modes described below).

7. To exit Z-Wave range test, press the B-button briefly.

Z-Wave range tester signalling modes:

Visual indicator pulsing green - the Motion Sensor attempts to es-

tablish a direct communication with the main controller. If a direct

communication attempt fails, the device will try to establish a routed

communication, through other modules, which will be signalled by

visual indicator pulsing yellow.

Visual indicator glowing green - the Motion Sensor communicates

with the main controller directly.

Visual indicator pulsing yellow - the Motion Sensor tries to estab-

lish a routed communication with the main controller through other

modules (repeaters).

Visual indicator glowing yellow - the Motion Sensor communicates

with the main controller through the other modules. After 2 seconds

the device will retry to establish a direct communication with the

main controller, which will be signalled with visual indicator pulsing

green.

Visual indicator pulsing violet - the Motion Sensor does communi-

cate at the maximum distance of the Z-Wave network. If connection

proves successful it will be confirmed with a yellow glow. It's not rec-

ommended to use the device at the range limit.

Visual indicator glowing red - the Motion Sensor is not able to con-

nect to the main controller directly or through another Z-Wave net-

work device (repeater).