Sharp Carousel II R-1451 Посібник з приготування - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з приготування для Мікрохвильова піч Sharp Carousel II R-1451. Sharp Carousel II R-1451 30 сторінок.
Друкувати сторінку
Unpacking and Examining Your Oven
Carefully remove oven from carton_SAVE THE CARTON AS IT MAY MAKE
INSTALLATION EASIER_
Remove:
1o atl packing materials from inside the oven cavlty_ Check to see that there are
Installation Instructions, Wall Template and Top Template. Read enclosures and
SAVE the Operation Manual.
2. the feature sticker from the outside of the door, if there is one.
Check the oven for any damage, such as misaligned or bent door, damaged door
seals and sealing surfaces, broken or loose door hinges and latches and dents inside
the cavity or on the door. tf there is any damage, do not operate the oven and contact
your dealer or SHARP AUTHORIZED
SERVICER.
See Installation Instructions for more detaiis_
Hinges
Latches
Door seals and
saaJlng surtacas
Two optional accessories
are available for this oven:
1, Charcoal FillerKit (RK-220),,This is requiredwhen hoodexhaustis recirculated.See CharcoalFilter Kit on page 23.
If yourdealer does not stock this item, itcan be orderedby calling1-800-BE-SHARP.
2. FillerPanel Kit. For usewhenthe oven isinstalledin a 36qnchor 424nch wideopening° The metal filler panels come in pairs,
each 3-inches wide. For information contact:
Modern-Aire Manufacturing Corporation
7319 Lankershim Blvd°
North Hollywood, CA 91605
Phone: (818) 765-9870 or (213) B75-1350 Fax (81B) 765-4916
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. It must be
plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local
codes and ordinances, in the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape
wire for the electdc current,.
WARNING
- Improper use of the grounding plug can result in a risk of electric shock.
Electrical
Requirements
Check Installation Instructions for proper location for the power supply.
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected
electrical supply. It is recommended that a separate circuit serving only the oven be
provided_
The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall
receptacle
that is properly
installed
and grounded,,
DO NOT UNDER
ANY
CIRCUMSTANCES
CUT OR REMOVE THE GROUNDING PiN FROM THE PLUG.
3oProng Plug
Grounding Pin
3-Prong
Receptacle
_
Ground
Receplac_e Box
Note:
1. tf you have any questions about the grounding or electrical instructions, consult a qualified electrician or service person,
2. Neither Sharp nor the dealer can accept any liability for damage to the oven or personal injury resulting from failure to observe
the correct electrical connection procedures,.
Radio
or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave
oven is on a
different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and signal of receiving
antenna