Sharp Carousel R-1871 Інструкція з монтажу Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Мікрохвильова піч Sharp Carousel R-1871. Sharp Carousel R-1871 8 сторінок. Over-the-range microwave oven/hood system
Також для Sharp Carousel R-1871: Посібник з експлуатації (32 сторінок), Брошура та технічні характеристики (8 сторінок), Посібник з монтажу (9 сторінок), Доповнення до інструкції з експлуатації (24 сторінок)

Wire Box

C. VERTICAL EXHAUST: Outside Ventilation

1. Remove and save the 4 screws from the Fan Cover Bracket. Remove Fan

Cover Bracket by sliding it in the opposite direction of the arrow on the Fan

Cover Bracket as shown in Figure 13.

2. Lift the Hood Fan Unit carefully and slip wires out of cavity. See Figure 14.

CAUTION: Do not pull or stretch hood fan wiring.

3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing

the back of the oven. Note, you will need to lift the wire over the hood fan

unit so the wire will clear. See Figure 15 (A). Then rotate the Hood Fan

Unit 90˚ so that the fan blade openings are facing the top of the oven. See

Figure 15 (B). Replace Hood Fan Unit into the oven. Be careful not to

pinch the lead wire between the inner bracket and the Hood Fan Unit. Put

the lead wire into Wire Box. See Figure 15 (C).

4. Replace the Fan Cover Bracket. Make sure the fan blades are visible

through the top openings in the oven before proceeding.

5. Attach the Fan Cover Bracket to unit with the 4 screws removed in step 1

above. See Figure 16. The Hood Fan Unit is now rotated for vertical

exhaust operation.

6. Attach the Exhaust Damper Assembly to the fan cover on the top of the

outercase cabinet by sliding it into the slits in the same direction as the

arrow. Use 1 Tapping Screw 4 X12 mm from the INSTALLATION HARD-

WARE and tighten into place. See Figure 17.

Wire Box

Figure 11

(B)

Figure 16

Fan Cover Bracket

(A) Rotate 180˚

(C)

Mounting Plate

(Back side)

Figure 12

Figure 13

Figure 14

Figure 15

Exhaust Damper Assembly

Figure 17