Sharp Carousel R-306L Посібник з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Мікрохвильова піч Sharp Carousel R-306L. Sharp Carousel R-306L 25 сторінок. Operation manual
Також для Sharp Carousel R-306L: Посібник з експлуатації (25 сторінок)
Друкувати сторінку
Unpacking and Examining Your Oven
Remove:
1. all packing materials from inside the oven cav-
ity;
however,
DO
NOT
REMOVE
THE
WAVEGUIDE COVER, which is located on the
right cavity wall. Read
_afety door lalches
.
m/enclosures
and SAVE
[')the Operation Manual.
!1
III _1(2. the feature sticker, if
_L[
JJ_I')there
is one, from the
_ outside of the door.
_
_( Check the oven for any
De_'Jorsealsand
Waveguide_damage, such as mis-
Ning
sealingsulfaces
cover
aligned
or bent door,
damaged
door seals
and sealing surfaces, broken or loose door hinges
and latches and dents inside the cavity or on the
door. If there is any damage, do not operate the
oven and contact your dealer or SHARP
AUTHORIZED
SERVICER.
Choosing
a Location for Your Oven
You will use the oven frequently so plan its loca-
tion for ease of use. It's wise, if possible, to have
counter space on at least one side of the oven.
Allow at least 2 inches (50 mm) on the sides, top
and at the rear of the oven for air circulation. Do
not place or install the oven in any area where
heat and steam are generated; for example, next
to or above a conventional
gas or electric range
or above a conventional
wall oven. Heat and
steam may damage the electronics
or the me-
chanical parts of the oven.
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a
grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in
accordance with the National Electrical Code and local codes and ordinances. In the event of an electri-
cal short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric
current.
WARNING
- Improper use of the grounding plug can result in a risk of electric shock.
Electrical
Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more
protected electrical supply. It is recommended that a separate circuit serv-
ing only this appliance be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged
into a wall receptacle that is properly installed and grounded. Should you
only have a 2-prong outlet, have a qualified electrician install a correct wall
receptacle.
A 3-prong adapter may be purchased and used temporarily if local codes
allow. Follow package directions.
A short power-supply cord is provided to reduce risk of becoming entangled
in or tripping over a longer cord.
Permanent
and Correct
_nstaiiation
3-Prong P:ug
3-Prong Receptac:e _¢_
Ground "/
Receptac:e Box
Temporary
Use
ExtensionCord
If it is necessary to use an extension cord, use only a 3-wire extension cord
that has a 3-blade grounding plug and a 3-slot receptacle that will accept
the plug on the microwave oven. The marked rating of the extension cord
should beAC 115-120 volt, 15 amp. or more.
Be careful not to drape the cord over the cou ntertop or table where it can be
pulled on by children or tripped over accidentally.
Notes: 1. If you have any questions about the grounding or electrical in-
structions, consult a qualified electrician or service person.
2. Neither Sharp nor the dealer can accept any liability for damage
to the oven or personal injury resulting from failure to observe the
correct electrical connection procedures.
Ground
Glound]ng
Receptac:e
BOX
Adapter
Radio or TV Interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the
microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as
feasible or check position and signal of receiving antenna.
4