Sharp Aquos LC 32GD9E Посібник з експлуатації - Сторінка 17
Переглянути онлайн або завантажити pdf Посібник з експлуатації для РК-ТЕЛЕВІЗОР Sharp Aquos LC 32GD9E. Sharp Aquos LC 32GD9E 40 сторінок. Lcd colour television
Друкувати сторінку
Menu operations
Auto Vol.
Menu Operation: A (page 12)
Different sound sources, fairly often do not have the
same volume level, for example the changing from
movie to the advertisements. The Automatic Volume
Control (Auto Vol.) solves this problem and equalises
the volume levels.
Clear Voice
Menu Operation: A (page 12)
This function emphasises speech voice against the
background noise for more intelligibility. It is not
recommended for music sources.
Power Control menu
MENU
[ Power Control ]
Audio
No Signal Off
No Operation Off
No Signal Off
Menu Operation: A (page 12)
When set to "Enable" the TV will automatically enter
the standby mode if there is no signal input for 15
minutes.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
No Operation Off
Menu Operation: A (page 12)
When set to "Enable" the TV will automatically enter
the standby mode if no operations are performed for
3 hours.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
Power Management
Menu Operation: A (page 12)
When set, the TV will automatically enter the standby
mode.
Item
Off:
• No power management
• Factory preset value.
Mode1: • If there is no signal input for 8 minutes, the TV
enters the standby mode.
• Even if you start using the PC and the signal
inputs again, the TV stays in standby mode.
• The TV turns on again by pressing a on the
TV or B on the remote control unit. (See page
8.)
Mode2: • If there is no signal input for 8 seconds, the
TV enters the standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on.
• The TV turns on again by pressing a on the TV
or B on the remote control unit. (See page 8.)
TV/DTV/AV only
Power Control
[Disable]
[Disable]
TV/AV only
TV/DTV/AV only
PC only
Setup menu
MENU
[ Setup ]
Setup
Auto Installation
Programme Setup
Child Lock
Position
WSS
[On]
4:3 Mode
[Panorama]
Rotate
[Normal]
Language
[English]
Supply Voltage
[Off (0V)]
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Auto Installation", and then
press OK.
If you have already set the PIN under "Child Lock",
enter it here.
• See page 17 for setting PIN.
4
Press c/d to select "Yes", and then press OK.
5
You can set language and country the same as in
the initial auto installation. Follow steps 1 and 2
on page 8.
Programme Setup
This section describes how to set up analogue TV
channels manually.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Programme Setup", and
then press OK.
If you have already set the PIN under "Child Lock",
enter it here.
• See page 17 for setting PIN.
4
Press a/b to select "Auto Search", "Manual
Adjust", "Sort" or "Erase Programme", and then
press OK.
Auto Search
Manual Adjust
Sort
Erase Programme
Option
TV only
TV only
No
Yes
15