DIGISYSTEM AP00010G Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Джерело живлення DIGISYSTEM AP00010G. DIGISYSTEM AP00010G 9 сторінок.

PROBLEMS SOLUTION

fault

Led DL2 switches regularly on and off

At power on the led DL2 doesn't switch

momentary on and DL1 doesn't switches

at all

At power on the led DL1 is off and led

DL2 switches momentary on, but

vibration doesn't start

At power on the led DL1 switches on

and led DL2 switches momentary on,

but vibration doesn't start

If actions remarked on the table doesn't resolve the problem you may contact factory

digisystem srl (e-mail

As on the electronic card there are some capacitors with high voltage applied (presence of

residuary energy, danger of strike) you must wait at least 4 - 5 minutes after the device is

disconnected from the power supply, before opening the box.

Remove the four screws on the panel.

Downloaded from StockCheck.com

start command

functional

anomaly

Overload

Decrease reference voltage to

condition

decrease the output power

Device not

Verify mains supply and input

supplied

fuses; to locate fuses F1 see

instructions to open the device

There is not

Place switch SW2 to on or send

a start command from input

Vibrator not

Check wiring from power

supplied

supply to vibrator; if the

problem is not there may be

there is a failure on drivers into

) we will help you.

What to do

cable

the power supply