Sharp CD-BA150 Посібник з експлуатації - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Стереосистема Sharp CD-BA150. Sharp CD-BA150 18 сторінок. Sharp stereo system user manual
Також для Sharp CD-BA150: Короткий посібник (2 сторінок)

Sharp CD-BA150 Посібник з експлуатації

USING EXTERNAL UNITS

To the line output jack

RESETTING THE MICROCOMPUTER

POWER
ON/
STAND-BY

TRANSPORTING THE UNIT

POWER
ON/
STAND-BY
CD
To listen to or record signals from external sources
through this unit:
1
RCA
2
cord
3
4
5
Note:
Reset the microcomputer under the following conditions:
X-BASS/
DEMO
1
2
Caution:
Before you move this product to a new location, proceed
OPEN/
as follows:
CLOSE
1
2
3
4
5
15
Video/Auxiliary (Audio signal) input
Use a separately available RCA cord to connect the desired
external unit to the VIDEO/AUX jacks.
(red
right channel, white
When using video equipment (Laser Disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
Press the ON/STAND-BY button to turn the power on.
Press the VIDEO/AUX button.
Operate the external unit.
To record the sound from the external unit, perform steps 2
- 4 of the "Recording from the built-in radio" section on page
13.
To prevent hum interference, do not place this unit near a
television receiver.
Headphones
Before plugging in or unplugging the headphones, make sure
the volume level is reduced.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for the
desired volume.
To erase all of the stored memory contents (clock and timer
settings, and tuner and CD presets).
If the display is not correct.
If the operation is not correct.
Press the ON/STAND-BY button to enter the stand-by mode.
While pressing down the
button, hold down the ON/STAND-BY button for at least 1
second.
"CLEAR AL" will appear.
The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
Press the ON/STAND-BY button to turn the power on.
Press the CD button.
Press the OPEN/CLOSE button to open the disc tray.
Remove all CDs inserted in the unit.
Press the OPEN/CLOSE button to close the disc tray.
Make sure that "NO DISC" is displayed.
Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power cord from the AC outlet.
left channel)
button and the X-BASS/DEMO
0 / R