Sharp CD-BH20 Посібник з експлуатації - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Стереосистема Sharp CD-BH20. Sharp CD-BH20 21 сторінка.

Друкувати сторінку

Enhancing your system

The connection cord is not included. Purchase a commer-

cially available cord as shown below.

Audio cable (not supplied)

■ Listening to the playback sounds of

portable audio player, etc.

Use a connection cord to connect the portable audio

player, etc. to the AUDIO IN jack.

Press the

(ON/STANDBY) button to turn the power on.

Press the INPUT (AUDIO/LINE (INPUT)) button (main

unit or remote control) repeatedly to select AUDIO IN

function.

Play the connected equipment. If volume level of the

connected device is too high, sound distortion may

occur. Should this happen, adjust the volume of the

connected device.

Note:

To prevent noise interference, place the unit away from

the television.

■ Headphones

● Do not set the volume on to maximum at switch on.

Excessive sound pressure from earphones and head-

phones can cause hearing loss.

● Before plugging in or unplugging the headphone, re-

duce the volume.

● Be sure your headphone has a 1/8" (3.5mm) diameter

plug and impedance between 16 and 50 ohms. The

recommended impedance is 32 ohms.

● Plugging in the headphone disconnects the speakers au-

tomatically.

Portable audio

player, etc.

E-17

Troubleshooting chart

If something is wrong with this product, check the following be-

fore calling your authorized SHARP dealer or service center.

■ General

Symptom

● The clock is not set to

the correct time.

● When a button is

pressed, the unit does

not respond.

● No sound is heard.

■ Remote control

Symptom

● The remote control

does not operate.

■ Tuner

Symptom

● The radio makes

unusual noises

continuously.

■ Bluetooth

Symptom

● No sound is heard.

● Bluetooth sound is in-

terrupted or distorted.

Possible cause

● A power failure occurred.

Reset the clock. (Refer

page 8)

● Set the unit to the power

standby mode and then

turn it back on.

● If the unit still malfunc-

tions, reset it. (Refer page

18)

● The volume level set to

"Volume Min".

● The headphones are con-

nected.

Possible cause

● The AC power cord of the

unit is not plugged in.

● The battery polarity is

wrong.

● The batteries are dead.

● The distance or angle is

incorrect.

● The remote control sensor

receives strong light.

Possible cause

● The unit placed near a TV or

computer.

● The FM/AM antenna is not

placed properly. Move the

antenna away from the AC

power cord if it is located

nearby.

Possible cause

● The unit is too far from the

Bluetooth audio source

device.

● The unit is not paired

with the Bluetooth audio

source device.

● The unit is too near to

a device that generates

electromagnetic radiation.

● There is an obstacle

between the unit and the

Bluetooth audio source

device.