Sharp CD-DH790N Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Стереосистема Sharp CD-DH790N. Sharp CD-DH790N 23 сторінки. Sony stereo system user manual
Друкувати сторінку
Remote control
■ Battery installation
1
Open the battery cover.
2
Insert the batteries according to the direction indicated in the battery
compartment.
When inserting or removing the batteries, push them toward the (–) battery
terminals.
3
Close the cover.
Caution:
● Replace all old batteries with new ones at the same time.
● Do not mix old and new batteries.
● Remove the batteries if the unit will not be used for a long period of time.
This will prevent potential damage due to battery leakage.
● Do not use rechargeable batteries (nickel-cadmium battery, etc.).
● Installing the batteries incorrectly may cause the unit to malfunction.
● Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
Notes concerning use:
● Replace the batteries if the operating distance is reduced or if the
operation becomes erratic. Purchase 2 "AAA" size batteries (UM/SUM-3,
R6, HP-7 or similar).
● Periodically clean the transmitter on the remote control and the sensor on
the unit with a soft cloth.
● Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit if this occurs.
● Keep the remote control away from moisture, heat, shock, and vibrations.
■ Test of the remote control
Check the remote control after checking all the connections.
Point the remote control directly at the remote sensor on the unit. The remote
control can be used within the range shown below:
Remote sensor
8" - 20'
(0.2 m - 6 m)
AUDIO IN
AUDIO IN
PHONES
PHONES
MI N I C O MP O N E N T S Y ST EM
CD-DH790
FUNCTION
FUNCTION
POWER
POWER
ON/STAND-BY
ON/STAND-BY
VOL
VOL
PUSH
PUSH
OPEN
OPEN
General control
POWER
POWER
ON/STAND-BY
ON/STAND-BY
■ To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
■ Display brightness control
To dim the display brightness, hold down the CLEAR/DIMMER button on the
remote control for 2 seconds or more.
■ Volume auto fade-in
If you turn off and on the main unit with the volume set to 27 or higher, the
volume starts at 16 and fades in to the last set level.
■ Volume control
Turn the volume knob toward VOL +/– (on main unit) or press VOLUME +/–
(on remote control) to increase or decrease the volume.
■ X-Bass control
When the power is first turned on, the unit will enter the extra bass mode which
emphasizes the bass frequencies, and "X-BASS" will appear. To cancel the
extra bass mode, press the X-BASS button on the remote control.
■ Bass control
1
Press the BASS/TREBLE button to select "BASS".
2
Within 5 seconds, press the VOLUME (+ or –) button to adjust the bass.
■ Treble control
1
Press the BASS/TREBLE button to select "TREBLE".
2
Within 5 seconds, press the VOLUME (+ or –) button to adjust the treble.
■ Equalizer
When the EQUALIZER MODE button is pressed, the current mode setting will
be displayed. To change to a different mode, press the EQUALIZER MODE
button repeatedly until the desired sound mode appears.
FLAT
GAME
CLASSIC
POPS
VOCAL
JAZZ
E-6
M I NI CO M PO NENT SYST E M
CD-DH790
FUNCTION
FUNCTION
POWER
POWER
ON/STAND-BY
ON/STAND-BY
VOL
VOL
CD
USB
No equalisation.
No equalization.
For game.
For rock music.
For classical music.
For classical music.
For pop music.
For pop music.
Vocals are enhanced.
Vocals are enhanced.
For jazz.
For jazz.