Sharp CD-ES600 Посібник з експлуатації - Сторінка 26

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Стереосистема Sharp CD-ES600. Sharp CD-ES600 36 сторінок. Sharp mini component system operation manual cd-es600 ,cd-es66

Друкувати сторінку

CD-ES600

Recording on a cassette tape (continued)

CD-ES66

Recording from several CDs continuously:

1 Perform steps 1 - 5 in "Recording from a CD (CDs)" on page 25.

2 Within 5 seconds, press the

To perform programmed recording:

1 Program discs and tracks. (See page 20.)

2 Press the

button.

3 Press the

To stop recording:

Press the

button.

The CD and tape will stop.

! Recording from the radio

Tune in to the desired station. (See page 21.)

Load a cassette into the TAPE 2 cassette compartment

with the side to be recorded on facing you.

Wind past the leader of the tape, on which recording cannot be

performed.

Press the

button.

Recording will be paused.

Press the

To interrupt recording:

Press the

button.

To resume recording, press the

To stop recording:

Press the

button.

Note:

If you hear a whistling noise while recording an AM station, move

the AM loop antenna.

button to start recording.

button.

! Dubbing from tape to tape

You can record from TAPE 1 to TAPE 2.

Press the ON/STAND-BY button to turn the power on.

Load a prerecorded cassette

into the TAPE 1 cassette com-

partment. Insert a blank tape

into the TAPE 2 cassette com-

partment.

It is recommended that the recording tape is the same length as

the master tape.

Press the TAPE (1

2) button until "TAPE 1" appears on

the display.

Press the

button.

Recording will be paused.

Press the

button to start dubbing.

To stop dubbing:

Press the

button.

TAPE 1 and TAPE 2 will simultaneously stop.

! Erasing recorded tapes

Load the tape to be erased into the TAPE 2 cassette compart-

ment with the side to be erased facing toward you.

Press the TAPE (1

2) button until "TAPE 2" appears on the dis-

play.

Press the

button.

Press the

button to start erasing.

Note:

Make sure that the TAPE 1 is not in use.