Sharp AL-2061 Посібник з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Принтер "Все в одному Sharp AL-2061. Sharp AL-2061 44 сторінки.
Також для Sharp AL-2061: Посібник з експлуатації (49 сторінок)

Sharp AL-2061 Посібник з експлуатації
CAUTIONS
Each instruction also covers the optional units used with the product.
Caution label on the machine
The label (
) in the fusing area of the machine indicates the following:
: Caution, risk of danger
: Caution, hot surface
Cautions on using the machine
Follow the cautions below when using this machine.
Warning:
• The fusing area is hot. Exercise care in this area when removing misfed paper.
• Do not look directly at the light source. Doing so may damage your eyes.
• Do not switch the machine rapidly on and off. After turning the machine
off, wait 10 to 15 seconds before turning it back on.
• Machine power must be turned off before installing any supplies.
Caution:
• Place the machine on a firm, level surface.
• Do not install the machine in a humid or dusty location.
• When the machine is not used for a long time, for example for consecutive
holidays, turn the power switch off and remove the power cord from the outlet.
• When moving the machine, be sure to turn the power switch off and remove the
power cord from the outlet.
• Do not cover the machine with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the machine.
• Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
• The socket-outlet shall be installed near the machine and shall be easily accessible.
Important points when selecting an installation site
Do not install your machine in areas that are:
• damp, humid, or very dusty
• exposed to direct sunlight
• poorly ventilated
• subject to extreme temperature or humidity changes, e.g., near an air
conditioner or heater.
Be sure to allow the required space around
the machine for servicing and proper
ventilation.

Cautions on handling the machine

Be careful in handling the machine as follows to maintain the performance of this
machine.
Do not drop the machine, subject it to shock or strike it against any object.
Do not expose the drum cartridge to direct sunlight.
• Doing so will damage the surface (green portion) of the drum cartridge, causing
smudges on copies.
Store spare supplies such as drum cartridges and TD (Toner/Developer) cartridges in a
cool dry place without removing from the package before use.
• If they are exposed to direct sunlight, or excessive heat, poor copies may result.
Do not touch the surface (green portion) of the drum cartridge.
• Scratches or smudges on the drum will cause dirty copies.
Supply and Consumables
The supply of spare parts for a repair of the appliance is guaranteed for at least 7 years
following the termination of production. Spare parts are those parts of the apparatus which
may break down within the scope of ordinary use of the product, whereas those parts
which normally exceed the life of the product are not considered spare parts. Consumables
also, are available for 7 years following the termination of production.
Trademark acknowledgements
®
®
®
• Microsoft
, Windows
, Windows
®
Windows
Server 2008, Windows Vista
registered trademarks or trademarks of Microsoft Corporation in the U.S.A. and other
countries.
• Macintosh is a trademark of Apple Inc., registered in the U.S. and other countries.
• IBM, PC/AT, and PowerPC are trademarks of International Business Machines Corporation.
• Adobe, the Adobe logo, Acrobat, the Adobe PDF logo, and Reader are registered
trademarks or trademarks of Adobe Systems Incorporated in the United States and
other countries.
• Sharpdesk is a trademark of Sharp Corporation.
• All other trademarks and copyrights are the property of their respective owners.
SOFTWARE LICENSE
The SOFTWARE LICENSE will appear when you install the software from the CD-
ROM. By using all or any portion of the software on the CD-ROM or in the machine,
you are agreeing to be bound by the terms of the SOFTWARE LICENSE.

ENVIRONMENTAL INFORMATION

Products that have earned the ENERGY STAR
designed to protect the environment through superior
energy efficiency.
The products that meet the ENERGY STAR
The products without the logo may not meet the ENERGY STAR
4
20cm
10cm
®
®
2000, Windows
XP, Windows
Server 2003,
®
®
, Windows
7 and Internet Explorer
®
guidelines carry the logo shown above.
®
guidelines.
CAUTION:
Do not install the machine in a location with poor air circulation.
A small amount of ozone is created inside the machine during printing. The amount of ozone
created is not sufficient to be harmful; however, an unpleasant odor may be noticed during
large copy runs, and thus the machine should be installed in a room with a ventilation fan or
windows that provide sufficient air circulation. (The odor may occasionally cause headaches.)
* Install the machine so that people are not directly exposed to exhaust from the
machine. If installed near a window, ensure that the machine is not exposed to
direct sunlight.
In some areas, the "POWER" switch positions are marked "I" and " " on
the copier instead of "ON" and "OFF".
If your copier is so marked, please read "I" for "ON" and " " for "OFF".
Caution!
For a complete electrical disconnection, pull out the main plug.
The socket-outlet shall be installed near the equipment and shall
be easily accessible.
Shielded interface cables must be used with this equipment to maintain compliance with
EMC regulations.
Laser information
Wave length
Pulse times (North America)
Output power
At the production line, the output power of the scanner unit is adjusted to 0.18
MILLIWATT PLUS 5% and is maintained constant by the operation of the Automatic
Power Control (APC).
Caution
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
This Digital Equipment is CLASS 1 LASER PRODUCT (IEC 60825-1 Edition 1.2-
2001)
Caution
This product contains a low power laser device. To ensure continued safety do not
remove any cover or attempt to gain access to the inside of the product.
10cm
Refer all servicing to qualified personnel.
This product is designed for commercial application only and as such it falls outside
the scope of Regulation (EC) 1275/2008 implementing EU Directive 2005/32/EC on
eco-design requirements for standby and off mode electric power consumption. Sharp
does not recommend the product for domestic application and will not accept any
liability for such use.
Do not make copies of anything which is prohibited from copying by law. The
following items are normally prohibited from copying by national law. Other items
may be prohibited by local law.
Money
Bank drafts
Emission density (measured according to RAL-UZ122: Edition June, 2006)
Measured
chemicals
Ozone
Dust
Styrene
Benzene
®
are
TVOC

IMPORTANT SAFETY INSTRUCTIONS

• If any of your telephone equipment is not operating properly, you should immediately
remove it from your telephone line, as it may cause harm to the telephone network.
• The AC power outlet shall be installed near the equipment and shall be easily accessible.
• Never install telephone wiring during a lightning storm.
• Never install telephone sockets in wet locations unless the socket is specifically
designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a remote risk of electric shock from lightning.
• Do not use a telephone to report a gas leak in the vicinity of the leak.
• Do not install or use the machine near water, or when you are wet. Take care not to spill
any liquids on the machine.
• Save these instructions.
®
are
BATTERY DISPOSAL
THIS PRODUCT CONTAINS A LITHIUM PRIMARY MEMORY BACK-UP BATTERY THAT MUST BE
DISPOSED OF PROPERLY. PLEASE CONTACT YOUR LOCAL SHARP DEALER OR AUTHORIZED
SERVICE REPRESENTATIVE FOR ASSISTANCE IN DISPOSING OF THIS BATTERY.
780 nm
+15 nm
-10 nm
12.88 µs ±12.88 ns/7 mm
Max 0.2 mW
Stamps
Bonds
Checks
Passports
Condition of copier
Colour mode
When copier is in
Black and white
operation
When on standby
Stocks
Driver's licences
Diffusion speed
1.5 gm/h or less
4.0 gm/h or less
10 gm/h or less