Sharp AR-203E X Онлайн-посібник - Сторінка 29

Переглянути онлайн або завантажити pdf Онлайн-посібник для Принтер "Все в одному Sharp AR-203E X. Sharp AR-203E X 39 сторінок. Digital multifunctional system
Також для Sharp AR-203E X: Посібник з експлуатації принтера (44 сторінок), Листівка із застереженнями (37 сторінок)

Друкувати сторінку

Faint, Uneven or Smeared Print Output

If print output is faint, uneven or smeared, follow the steps listed below.

CHECK 1

Has the printer driver been specified to suit

both paper and the print job?

You can select "Draft", "Normal" or "Photo" for the

print quality in the "Advanced" tab of the printer

driver setup screen. When "Photo" is selected, you

can click the "Image Adjustment" button and adjust

the brightness and contrast in the dialog box that

appears. Adjust these settings appropriately for

your print data and try printing again.

Reference:

Printer Driver Settings

CHECK 2

Is the paper curled?

If the paper is curled, straighten it up and set it in

the unit again.

CHECK 3

Is the paper too thick or too thin?

Only paper weighing from 56 to 80g/m

used in the paper tray. Only paper weighing from 56

to 128g/m

can be used in the multi-bypass tray.

CHECK 4

Is the developer replacement required

indicator lit?

When the developer replacement required (

indicator lights up, the developer should be

replaced. DEVELOPER REPLACEMENT SHOULD

ONLY BE DONE BY AN AUTHORISED SHARP

SERVICE TECHNICIAN. Contact your service

centre as soon as possible.

CHECK 5

CHECK 6

can be

CHECK 7

)

Is it near time to replace the TD cartridge or

drum cartridge?

When it is near time to replace the toner cartridge,

the toner cartridge replacement required (

indicator will light up on the unit operation panel.

When it is time to replace the cartridge, the

indicator will blink. Replace the cartridge and try

printing again.

Reference:

See "TONER CARTRIDGE

REPLACEMENT", in the Operation Manual.

Is the maintenance indicator lit?

When the maintenance (

service by an authorised SHARP service technician

is required. Contact your service centre as soon as

possible.

Did you set sufficient margins in the paper

settings of your application?

If the margins are set outside of the quality

guaranteed area, smudges or smears may appear

at the upper and lower edges of the paper.

When selecting the paper settings in the

application, set the margins from the top, bottom,

left and right edges of the paper to 4 mm.

CONTENTS

INDEX

)

) indicator lights up,