Colour adjustments
This program is used to perform manual or automatic
adjustment of colour tone (cyan, magenta, yellow, and
black), and adjustment of grey balance in middle-
density areas.
A test page can also be printed to verify the results of
the adjustments.
None of these adjustments affect black and white
printing.
The following selections are available in [Colour
adjustments].
G Easy calibration
G Colour balance
G Test print
See the accompanying "Colour Adjustment" manual
for detailed explanations of these functions.
Initialize and/or store settings
You can restore the CONDITION SETTINGS
2) and the key operator program of the PRINTER
SETTINGS of
(page
6-5) to the factory default settings.
You can also store the current configuration of these
settings in memory, and restore a stored configuration
at a later time.
I I I I Restore factory defaults
This restores the CONDITION SETTINGS
and the key operator program of the PRINTER
SETTINGS of
(page
6-5) to the factory default settings.
If you need a record of the settings prior to restoration
of the default settings, print the CUSTOM SETTINGS
list ("Operation manual (for general information and
copier operation)" page 2-14) and the key operator
program list ("page 2 of Key operator's guide").
This does not affect "Colour adjustments" in the
PRINTER SETTINGS.
NOTE
After this program is set, exit the key operator
program, turn off the main switch, and then turn on
the main switch again after at least 3 seconds. The
program will be effective at this time.
TABLE OF CONTENTS
I I I I Store current configuration
This program is used to store the CONDITION
SETTINGS
PRINTER SETTINGS of
stored settings will remain in memory even if the main
switch is turned off. To read the stored settings, use the
following [RESTORE CONFIGURATION] program.
This does not affect "Colour adjustments" in the
PRINTER SETTINGS.
I I I I Restore configuration
This program is used to read the configuration that was
stored
CONFIGURATION] program and restore it as the
current configuration.
The currently set configuration will change to the
configuration read from memory.
(page 4-
(page
4-2)
BEGINNING OF CHAPTER
DESCRIPTION OF SETTING PROGRAMS
(page
4-2) and the key operator program
(page
6-5) in memory. The
using
the
[STORE
6-7
CURRENT
Друкувати сторінку