Sharp AR-M256 Посібник ключового оператора - Сторінка 21
Переглянути онлайн або завантажити pdf Посібник ключового оператора для Принтер "Все в одному Sharp AR-M256. Sharp AR-M256 24 сторінки. Digital multifunctional system key operator's guide
Також для Sharp AR-M256: Посібник з експлуатації (4 сторінок), Онлайн-посібник (36 сторінок), Посібник з налаштування (20 сторінок), Посібник з експлуатації (48 сторінок)
Друкувати сторінку
ENABLE EtherTalk
This program must be enabled to use the machine on
a network that uses EtherTalk protocol.
This program is initially enabled (factory default setting).
ENABLE NetBEUI
This program must be enabled to use the machine on
a network that uses NetBEUI protocol.
This program is initially enabled (factory default
setting).
*1
RESET THE NIC
This program is used to restore all network settings to
the factory default settings.
PROGRAMS FOR PRINT MODE
INITIALISE AND/OR STORE SETTINGS
(When the PRINTER EXPANSION KIT is installed)
These programs are used to return the configuration
settings (See the online manual for network printer)
and the "PRINT SETTINGS" (p.16) to the factory
default settings. The programs are also used to store
the current settings and to restore stored settings.
"INITIALISE AND/OR STORE SETTINGS" consists of
the following programs:
● RESTORE FACTORY DEFAULTS
● STORE CURRENT CONFIGURATION
● RESTORE CONFIGURATION
Some programs in the following are marked
Note
by "*1". This indicates that a message will
appear at the end of the setting procedure
asking you to confirm execution of the new
setting. If needed, you can cancel the new
setting by touching the [NO] key.
RESTORE FACTORY DEFAULTS
This program is used to return the configuration
settings (see the online manual for network printer)
and the "PRINT SETTINGS" (p.16) to the factory
default settings. If you need a record of the current
settings before restoring the factory defaults, use
"Data list print" in the user settings to print a list of the
current settings. (See "CUSTOM SETTINGS" in the
operation manual for copier.)
STORE CURRENT CONFIGURATION
This program is used to store the current configuration
settings (see online manual for network printer) and
"PRINT SETTINGS" (p.16). The stored settings will not
be erased even if the power is turned off. To restore
the stored settings, use the "RESTORE
CONFIGURATION" program.
RESTORE CONFIGURATION
This program is used to restore settings that were
stored using the "STORE CURRENT
CONFIGURATION" program.
The current settings will change to the restored
settings.
If any of the "NETWORK SETTINGS" (p.18)
Note
were changed before execution of this
program, you must turn off the machine's
power switch, wait briefly, and then turn the
switch back on in order to make the settings
take effect.
*1
*1
*1
19