Sharp X-M200DK Посібник з монтажу - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з монтажу для Принтер "Все в одному Sharp X-M200DK. Sharp X-M200DK 38 сторінок. Digital multifunctional system

Друкувати сторінку

[7] MX-NB10

1. UNPACKING AND INSTALLATION

1-1. UNPACKING

1-2. PACKAGED GOODS

1-3. INSTALLATION PROCEDURE

Turn off the main switch of the main unit and remove the power

plug of the main unit from the outlet.

1) Cut out the cut-out portions from the rear cabinet.

1) Cut out three cut-out portions from the rear cabinet using a cutter or

the like.

2) Use a Phillips screwdriver or the like to open a hole.

Phillips screwdriver

2) Attach the network expansion kit.

Connect the connector of the network expansion kit to the connector of

the main unit and put excessive harness into the cut-out portion in the

main unit.

Engage the two pawls on the rear of the network expansion kit with the

cut-out portions of the main unit and network expansion kit using the

supplied screw (3 x 14).

3) Connect the USB cable and the network cable.

1) Attach the supplied cable clamp to the position shown in the illustra-

2) Connect the USB cable to the network expansion kit and the main

3) Connect the network cable.

Insert the power plug of the copier to the outlet, turn the main

switch of the copier to the "ON" position, and perform network set-

ting and installation of the software.

MX-NB10 7 - 1

Screw (M3x14)

Pawl

tion.

unit. At this time, reduce slack of the cable with the cable clamp as

shown in the illustration.

Connector

Pawl