Sharp SJB1255GS Посібник з експлуатації та інструкція з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з експлуатації та інструкція з монтажу для Холодильник Sharp SJB1255GS. Sharp SJB1255GS 17 сторінок.
Друкувати сторінку
INSTALLATION INSTRUCTIONS
INSTALLATION LOCATION
• This refrigerator is designed for indoor, household use only.
• Keep away from heat and avoid direct sunlight or places near
a heat source, such as an oven or a radiator.
• Do not place the refrigerator in moist or watery places to
prevent rust or reduction of insulating effect to affect the
electrical insulation properties of the refrigerator.
• The refrigerator is placed in a dry and well-ventilated indoor
place.
• The ground shall be flat, and sturdy (rotate the adjustable leg
left or right to adjust for leveling if unstable.)
• The temperature of the location ranges from a minimum of
55°F to a maximum of 110°F. However, for better energy
usage and superior cooling, the temperature is preferred to
be between 60°F and 90°F.
• For proper air circulation and electric connections, allow a
2" clearance on each side and behind the refrigerator. Allow
a 2" clearance at top of the refrigerator.
• Spare enough space for convenient opening of the doors and
drawers, especially when the refrigerator is installed next to
a fixed wall to allow the door to swing open.
ELECTRICAL CONNECTION
Before plugging in, ensure that the voltage and frequency shown
on the rating plate correspond to your domestic power supply.
The appliance must be grounded. The power supply cable plug
is provided with a contact for this purpose. If the domestic
power supply socket is not grounded, connect the appliance
to a separate ground in compliance with current regulations,
consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety
precautions are not observed.
This appliance complies with the E.E.C. Directives.
DOOR REVERSIBILITY
Before reversing the door, please be prepared below tools and
material: phillips head screwdriver, socket wrench, wrench and
components included in the poly bag:
Left Door Hinge
Left Aid-Closer on
Cover x 1
Upper Door x 1
1. Unscrew top hinge cover and disconnect connector of door
2. Unscrew top hinge with screwdriver or ¼" socket wrench
3. Remove the pin with a wrench or 3/8" socket wrench and
Left Aid-Closer on
Lower Door x 1
8
TOOLS TO PREPARE
Phillips Head
Socket Wrench
Screwdriver
switch.
and remove the upper door.
flip the hinge bracket. Then refit the pin to the hinge bracket.
Unscrew
Wrench
Screw