Sharp Notevision PG-F211X Посібник з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Проектор Sharp Notevision PG-F211X. Sharp Notevision PG-F211X 24 сторінки. Multimedia projector
Друкувати сторінку
PG-F211X/PG-F261X
No.
Adjusting point
17
Model name and version check
18
Setup guide screen check
19
Delivery settings
* Writing a software program (before main PWB is mounted)
Use the DLP Composer Lite Ver. 4.2 to download the firmware.
After writing the specified version of firmware to the PWB using the RS232C cable, check the version of the written firmware.
If no software program is written, all three LEDs light up in the chassis inspection process.
Calling and quitting the process mode with the control keys on this model.
* Although it is possible for the process OUT to exit using the process menu, the IN/OUT toggle command is also available considering the existing
specification.
1) Calling and quitting
With the menu not displayed, press the "ENTER", "ENTER", "VOL+", "VOL-", "ENTER", "ENTER" and "MENU" keys on the remote control or on
the main unit.
2) Others
Press the S2551 process key (toggle) on the main PWB to call and quit the process menu.
NOTE: When adjusting in the process mode, set a signal with a vertical frequency of 60 Hz or no signal. (May not be properly adjusted with other sig-
nals.)
Resetting the lamp timer for this model
1) Resetting procedure
In Stand-by, run this command to clear the operating time of the lamp to 0 and turn on the power.
Press and hold "
", "ENTER", and "MENU", and then press the "STANDBY/ON" key of the set.
Forced disabling of the System-Lock of this model
1) Disabling procedure
With System-Lock input window onscreen, press the "MENU", "ENTER", "ENTER", "MENU", "ENTER", "ENTER" and "MENU" keys, in this order,
on the remote controller.
Adjusting conditions
1. Select the following group.
Group : INFO/VERSION.
1. Turn on the power after making the setup
guide display ON setting or factory setting
(SS4, etc.).
1. Make the following settings.
Destination
Process
adjustment
USA
SS4
2 – 3
Adjusting procedure
1. The model name appears in the MODEL field, and
the firmware version in the VERSION field. Check
that they are correct.
1. Check that the 4-split screen is displayed correctly
and the display contents are correct.
Remote control
adjustment
Factory setting at 4