Sharp XG-F315X Посібник з налаштування - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з налаштування для Проектор Sharp XG-F315X. Sharp XG-F315X 34 сторінки. Xga data projectors
Також для Sharp XG-F315X: Технічна специфікація (2 сторінок), Технічні характеристики (2 сторінок)
Друкувати сторінку
Setting up the Projector Network Environment
1. Connecting the Pro-
jector to a Computer
Establishing a one-to-one connection from the
projector to a computer. Using a LAN cable
(Category 5, cross-over type) you can config-
ure the projector via the computer.
1
Disconnect the computer's LAN
cable from the existing network.
2
Connect a LAN cable (a UTP
cable, Category 5, cross-over
type) to the projector's LAN ter-
minal and connect the other end
of the cable to the computer's
LAN terminal.
3
Plug the power cord into the AC
socket of the projector.
4
Turn on the computer.
Info
Confirm that the LINK LED on the rear of the
projector illuminates. If the LINK LED does not
illuminate, check the following :
• The LAN cable is properly connected.
• The power switches of both the projector
and the computer are on.
This completes the connection. Now proceed to "2. Setting an IP Address for the
Computer".
-10
A LAN cable being
connected to the network
LAN cable
(cross-over type, commercially available)
ON