Shimano ALFINE SG-S7001-11 Посібник дилера - Сторінка 28
Переглянути онлайн або завантажити pdf Посібник дилера для Велосипед Shimano ALFINE SG-S7001-11. Shimano ALFINE SG-S7001-11 48 сторінок.
![Shimano ALFINE SG-S7001-11 Посібник дилера](/uploads/products/server2/5080217/5080217.png)
Installation/removal
Installation of the hub to the frame
When securing the brake arm to the frame, be sure to use an arm clip that matches the size of the
chainstay, and securely tighten them with the clip bolt and clip nut to the specified tightening
torque.
Use a lock nut with nylon insert (self-locking nut) as the clip nut. It is recommended that SHIMANO
made clip bolts, clip nuts, and arm clips be used.
If the clip nut comes off the brake arm, or if the clip bolt or arm clip becomes damaged, the brake
arm may rotate on the chainstay and cause the handlebars to jerk suddenly, or the bicycle wheel
may lock and result in serious injury due to a fall or collision.
If it is not installed correctly, braking performance will suffer. Be very careful when installing it.
If excessive force is applied to the brake arm to secure it, a problem such as noise will occur and the
wheel will become difficult to turn.
After installing the arm clip, check that the clip bolt protrudes approximately 2 - 3 mm from the
end face of the clip nut.
2 - 3 mm
Clip nut
Before using the bicycle, check that the brake works properly and that the wheel turns smoothly.
Brake arm
Arm clip
Clip bolt
(M6 × 16 mm)
28