Digital Barriers EDGEVIS HD-IP450 Посібник з монтажу - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари Digital Barriers EDGEVIS HD-IP450. Digital Barriers EDGEVIS HD-IP450 16 сторінок.

EDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE
Appendix B – Vehicle Installation
The HD-IP450 unit is specifically designed for in-vehicle deployment. It
features a vibration-resistant mounting plate, battery power inputs
vibration-resistant storage caddy. A solid-state disk should be used for in-
vehicle applications.
Dimensions and fixings for in-vehicle installation
Ensure that you have adequate space to install the HD-IP450 mounting plate and unit with access to the camera
inputs, antenna connections and removable storage device on the front plate. The 9~36V battery input power
terminals are located on the rear plate of the unit and should be factored in when siting the unit in a vehicle.
Appendix C provides diagrams that outline all encoder dimensions and positioning of mounting holes.
Connecting the HD-IP450 to a vehicle battery
The HD-IP450 can be powered directly from a vehicle battery – either a 12V or 24V power source. When the ignition is
turned off the device will power down after a defined set time. To use the device while parked, apply power by turning
the key to accessory mode.
When installing in a vehicle, the following connections must be made to the power input connectors on the rear of the
unit:
Connect negative battery wire to the contact marked '-' on
the DC input connector
Connect positive battery wire to the contact marked '+' on
the DC Input connector
Connect ignition wire to the contact
marked 'IG' on the DC Input connector
ISSUED: 10 NOVEMBER 2020
DC Input 9~36V
_
+
IG
_
+
PAGE 13