Digital Combo DK20S Посібник - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник для Електроінструмент Digital Combo DK20S. Digital Combo DK20S 20 сторінок. Multi-purpose press

The following information attempts to address the most probable

mechanical and user issues with the press. Most issues with heat

transfer presses are application related. That is, they have to do with

the results of a particular transfer application.

For technical support on problems having to do with the final

results of a particular transfer paper or media, please contact the

supplier of that transfer media. Generally, the machinery manufacturer

is unable to support the myriad of different transfer papers, inks and

imprintable items on the market from other resellers.

Q. The timer does not start when I close the heat platen, or the timer does

not reset when I open the press up.

A. There are several probable causes for this. The timer is activated by a

micro-switch under the head of the press. It is located on a sheet metal

bracket with slots. When the head of the machine is opened, the timer's

lever should be depressed and the small contact button under the lever

should click in. When the head for the machine is lowered, the lever

of the timer switch should move down and the contact button click

out. The timer switch may need to be loosened and moved along the

bracket to a position that allows for the heat platen cover to trigger the

switch. When tightening the switch against the bracket, do not

overtighten, the switch housing can crack very easily.

Q. The control displays Err when it first comes on, and I can not set the

temperature or use the press.

A. The Err message will display if the heating signal from the platen has

been cut off, interrupted, or the heating sensor has failed. Check that

the modular heat platen connector is properly plugged in and secured.

Then check the green heat connector that plugs into the digital control.

This is inside the top head. Unplug the power cord. Remove the two

screws in between the clamp/linkage that hold down the top panel, and

carefully lift the panel up and look inside at the digital controller. At the

top of the controller, there is a green connector that plugs in. This is the

temperature sensor wire. Check to make sure is it properly seated. Be

sure not to unplug any other connectors. The temperature wire connects

to the center of the rear half of the heat platen. Check this connection

as well to see if the connection is correct.