DIGITAL DELAY REPLAY TACH Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Блок управління DIGITAL DELAY REPLAY TACH. DIGITAL DELAY REPLAY TACH 9 сторінок.
Друкувати сторінкуFeatures:
• Microprocessor controlled timing
• Discrete I/O (input - output) construction
• Retains all numbers even with power disconnected from unit
• 2 row 16 character illuminated LCD (liquid crystal display) for easy reading of information day or night
• Data Lock feature
• Variable speed replay tach
• Tach-out terminal
• Help Screens for every feature of unit
• Shift on RPM up to 5 times
• Works on 4, 6, and 8 cylinder engines
• Small rugged case
• Built-in Replay Tach with two record speeds
• Digital data port for down loading
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Specifications:
• Input Voltage Range: 10 to 18 Volts DC ( 16 Volt compatible )
• Operating Temperature Range: 0 to 150 degrees F.
• Push-button Current: .1 AMPS at 12 VDC
• Tach and RPM Switch Range: 800 to 12750 in 50 RPM increments
• Two Outputs
• Shift Output rated at 15 Amps.
• Tach output
• Two Inputs
• P.B. Record
• Tach
Tach Terminal:
Record Push-Button Terminal:
button with the other wire for the push-button going to +12Volts.
Tach-Out Terminal:
Ground Terminal:
not aluminum.
Shift Terminal:
the REPLAY TACH with RPM SWITCH shift terminal to the shift solenoid be separated from all other wires to eliminate
cross talk between the wires. If all wires are bundled together undesirable results may occur.
+12VDC Terminal
Features and Specifications
The Terminal Strip
Connect the Tach terminal to the tach output on the ignition
Connect to the input on tachometer
Connect the Ground terminal to the Neg. terminal on the battery or to a good steel ground,
Connect the Shift terminal to the shifter solenoid. It is recommended that the wire going from
:
Connect the +12VDC terminal to a switched +12 Volt.
To start a recording of a pass, connect to one wire of a push-
.
3
.