Digital Electronics Corporation ST Series Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Digital Electronics Corporation ST Series. Digital Electronics Corporation ST Series 17 сторінок.

Друкувати сторінку

Connecting the ST Power Cord

When connecting the power cord, be sure to follow the procedures given below.

1. Confirm that the ST's power cord is unplugged from the power supply.

2. Remove the power plug from the ST unit.

3. Remove the vinyl cover of each of the power cord's wires and insert each wire

into the power plug's wire hole.

4. Replace the power plug.

• Use a flat screwdriver (Size 0.6 x 3.5) to tighten the terminal block wire set screws.

The torque required to tighten these screws is 0.5 to 0.6 N•m.

• Do not solder the wire itself.

Terminal block

wire set screws

E-14

Rear of ST

Power Plug