Digital Equipment AlphaStation 600 Series Інформаційний лист - Сторінка 3
Переглянути онлайн або завантажити pdf Інформаційний лист для Робочий стіл Digital Equipment AlphaStation 600 Series. Digital Equipment AlphaStation 600 Series 4 сторінки. 333 mhz upgrade
Друкувати сторінку14. Wrap the other ends of the cables one complete turn around the ferrite bead and pull them
snug (see Figure 2
15. Snap the ferrite bead closed on the cables.
16. Route the system board connector ends of the ribbon and twisted-pair OCP cables along the
bottom left of the power supply between the power supply and the left side panel (see Figure 2).
17. Install the new power supply front cover. Ensure that the ribbon and twisted-pair OCP cables
fit through the notched cutout in the upper left part of the cover, and that the ferrite bead fits
behind the protruding portion of the cover that is designed for it (see Figure 2).
18. Pull the excess ribbon and twisted-pair OCP cables into the system board area and dress the
cables under the flat metal fingers along the bottom left of the power supply (see Figure 2
19. Feed the 2-pin safety interlock cable connector through the opening in the front of the system
unit into the drive assembly area and reconnect it.
20. Reconnect the ribbon cable connector and the 4-pin twisted-pair cable connector to the OCP
(see Figure 2
).
21. With the ribbon and twisted-pair OCP cables extending out the left side of the OCP, snap the
OCP onto the front of the system unit (see Figure 2).
Figure 2: Rerouting the OCP Cables
).
2
4
3
1
3
).
MLO-011829