Siemens 1-3 Control Technology p1 Series Інструкції по встановленню/заміні - Сторінка 23
Переглянути онлайн або завантажити pdf Інструкції по встановленню/заміні для Промислове обладнання Siemens 1-3 Control Technology p1 Series. Siemens 1-3 Control Technology p1 Series 34 сторінки. Lighting panel
Друкувати сторінку
Chapter 6
System Components
Installing Data Rail Into Panel
1. Disconnect and lock off all power
sources supplying this panel.
2. Remove panel trim and deadfront.
3. Follow these guidelines for data
rail orientation.
a. Data rail PCB is facing
upward.
b.Ribbon connector is
positioned at the i-3
controller side.
4. Align the mounting holes of the
data rail brackets to the holes of
the panel deadfront support
bracket as shown in figure 6.13.
5. Install and tighten the screws (4
total on each data rail) to secure
the data rail position.
6. Loosen the screw (2 total) that
secures the data rail lid as shown
in figure 6.14 to open the lid for
CPOD and ribbon cable
connections.
7. Close the lid and tighten the
screws to secure the data rail lid
once all the connections are
properly made.
22
Figure 6.13
Installing data rail mounting bracket screws
Figure 6.14
Opening the data rail lid
Panel deadfront support bracket
Holes are
aligned
Data Rail
Mounting
Bracket
Loosen the screw
to open the lid