Siemens Simatic S7-400 Початок роботи - Сторінка 15

Переглянути онлайн або завантажити pdf Початок роботи для Промислове обладнання Siemens Simatic S7-400. Siemens Simatic S7-400 36 сторінок. Block library motor starter sirius for simatic pcs 7 sirius motor starter pcs 7 library v7.1+sp2 / sirius motor starter pcs 7 library v8 migration 8.0+sp1
Також для Siemens Simatic S7-400: Посібник (35 сторінок), Посібник (18 сторінок)

Друкувати сторінку

1. Table of Contents

Step

Action

If the hardware catalog is not visible, select the "View > Catalog" menu command.

•

Open the "PROFIBUS DP > ET 200S" folder in the standard hardware catalog.

•

Configure all modules listed in the table "ET 200S motor starter hardware".

•

Adding the IM151-1 HF module:

–

Select the IM151-1 HF module in the ET 200S folder.

Drag & drop the module to the "DP master system".

The dialog box "Properties - PROFIBUS DP Slave" opens.

–

Enter the PROFIBUS address.

This is the same address as the address of the device station of the motor starter.

–

Double-click the module to open the "Properties - DP Slave" dialog and switch to the "Operating

Parameters" tab.

–

Set the DP Interrupt Mode to DPV1.

–

Click "OK".

The defaults are accepted.

DP slave properties

Once the other modules (Page 8) (e.g., motor starter) have been added to the station, configure them in the same

way.

Note:

Enable group diagnostics for all modules.

SIRIUS Motor Starter PCS 7 Library "V7.1+SP2"/ "V8 Migration V8.0+SP1"

Getting Started, 08/2013, A5E02897539020A/RS-AA/005

First steps for the project

2.2 Configuring the device hardware