Digital Extender HD-D110 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Digital Extender HD-D110. Digital Extender HD-D110 11 сторінок. 1x10 hdmi distribution amplifier

Друкувати сторінку

3 Video Connection

1. Connect your video source's HDMI output port to the HD-D110's HDMI input port using

standard HDMI cables (not included). Make sure your entire HDMI source and the

displays are turned off before connecting the cables.

2. Connect your HDMI display's HDMI input port to HD-110's HDMI output port. Make sure

your HDMI display is turned off before connecting the cables.

3. Plug the 12V power supply into the switch's power input port.

4. Plug the 12V wall mount power supply into the wall outlet.

5. Turn on Distributor power.

6. Turn on your displays.

7. Turn on your video source.

External EDID and Internal EDID Set up

I. External EDID Set up

1. Disconnect all HDMI cable,

2. Connect Monitor or HDTV to "OUTPUT 1" back panel of Distributor

3. Turn on distributor and HDTV power

4. Push and hold the" EXTERNAL EDID" button in front of HD-D110 (4 sec)

5. Until RED LED light is on.

6. Turn off distributor

7. Reconnect all device follow the "Video Connection"

II. Internal EDID Set up

If you use EDID parameters factory pre-programmed inside the Distributor

1. Disconnect all HDMI cable

2. Turn on distributor power

3. Push and hold the" INTERNAL EDID" button front of HD-D110 (4 sec)

4. Until RED LED light is on.

5. Turn off distributor

6. Reconnect all device follow the "Video Connection"

**** EDID [Extended Display Identification Data]

EDID is defined by a standard published by the Video Electronics Standards Association (VESA).

The EDID includes manufacturer name, product type, phospher or filter type, timings supported by

the display, display size, luminance data and (for digital displays only) pixel mapping data.