Siemens 353 Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Контролер Siemens 353. Siemens 353 4 сторінки. Multi-purpose training panel
Також для Siemens 353: Посібник користувача (20 сторінок)
UMA353-1-6
10. Install the supplied cover as described in the illustration below. Use of larger gauge wires or wires
with very thick or very stiff insulation may prevent installation of the cover, or cause the cover to pop
off, unless the cable bundle is securely laced or tie wrapped.
To install or
remove cover:
squeeze
both sides
~1/16"
to clear
alignment
tabs.
Servicing Note
A Model 353 case with side entry connectors can be upgraded with direct entry connectors. Order the
Rear Terminal Upgrade Kit below.
Rear Terminal Upgrade Kit - PN16353-230
Includes:
Siemens Energy & Automation, Inc. assumes no liability for errors or omissions in this document or for the application and use
of information included in this document. The information herein is subject to change without notice.
Procedures in this document have been reviewed for compliance with applicable approval agency requirements and are
considered sound practice. Neither Siemens Energy & Automation, Inc. nor these agencies is responsible for repairs made by
the user.
Installing the Cover
Connector Socket Assembly
Connectors
Cover
To Install Terminal Cover:
1. Orient the cover as shown. Note the four hooked
tabs and Ethernet cable clearance cutout.
2. Squeeze the cover slightly at the two small cutouts
in the cover edges and fully insert the four hooked
cover tabs in the rear panel slots.
3. Allow cover sides to relax. Pull the cover straight
down until it snaps into place. The cutouts in the
cover edges will engage two alignment tabs on
the rear panel.
Where needed, the Ethernet cable should exit
through the large cutout in the cover.
To Remove Cover:
1. Squeeze the cover slightly at the two cutouts
in the cover edges (about 2" down from the
top of the cover) and push cover upward.
2. Pull cover out from rear panel.
Ethernet cable cutout.
4
n