Cisco 6800 Series Посібник користувача - Сторінка 13

Calls

Step 2

To deactivate DND, enter code to cancel do not disturb.

Use Push to Talk

You can use the handset as a two-way radio with the Push to Talk feature. The message is played over the

handset speaker automatically. Only 1 person at a time can use Push to Talk. If you press Mute while you

are receiving a Push to Talk message, the handset speaker mutes.

Before you begin

• You need Push to Talk enabled on your handset.

• At least one more handset in the system needs Push to Talk enabled.

Step 1

When your handset is idle, push and continue to hold Mute

Step 2

After the connected screen displays, you can talk.

Step 3

When your message is complete, release Mute.

You can page a group of phones or phone lines. Your administrator can create up to three paging groups.

Each paging group has a unique number. Your administrator gives you the configured paging group numbers.

When your handset receives a page, you see or hear the notification. You hear a beep or beeps notification

which is defined in the Call Progress Tones web page of the base station. You don't have to accept the page.

Here are the paging scenarios when your handset receives a page:

• If the handset is inactive, the page plays through the speakerphone.

• If the handset is active, the priority of the page determines the behavior as described in the following

Set Do Not Disturb

Turn on Push To Talk

table.

Table 1: Page Priority with Behavior

Priority

Alert

See and hear notification

Result

The active call goes on hold and the page plays.

Use Push to Talk

Calls