Epson 5000XB - PowerLite SVGA LCD Projector Бюлетень підтримки продукту - Сторінка 8
Переглянути онлайн або завантажити pdf Бюлетень підтримки продукту для Проектор Epson 5000XB - PowerLite SVGA LCD Projector. Epson 5000XB - PowerLite SVGA LCD Projector 9 сторінок. Product support bulletin(s)
Також для Epson 5000XB - PowerLite SVGA LCD Projector: Інформація про продукт (3 сторінок), Посібник користувача (1 сторінок), Технічна довідка (7 сторінок), Специфікація (1 сторінок)
Друкувати сторінку
TESTING THE REMOTE CONTROL UNIT
A
Install two fresh AA batteries in the Remote Control Unit battery compartment.
B.
Press one of the five function buttons on the Remote Control Unit. The RED LED on the
Remote Control unit should light.
HINT!: The the
C.
Press one of the five function buttons again while watching the POWER LED on the top
of the projector, the POWER LED should blink when the button is pressed. This
indicates the remote is communicating with the projector.
HINT!: The Remote Control Unit has a built in GO TO SLEEP function, to prolong the
life of batteries, if there is a period of inactivity on the remote. If the remote
goes to sleep, pressing one of the five function buttons will wake up the remote.
Point the Remote Control Unit at the front or the rear of the projector and slowly roll the
D.
trackball on the Remote Control Unit, the mouse pointer on the projected image should move.
If the mouse pointer does not move, refer to the IF YOU HAVE PROBLEMS section.
HINT!: Adjustments to the tracking speed of the Trackball, and Mouse button functions
can be changed in the SPECIAL pull down menu in the REMOTE
PROGRAMMER UTILITY.
USING THE REMOTE CONTROL UNIT
A.
Make sure the REMOTE PROGRAMMER utility software is running.
B.
Start your presentation software on the computer and use the Trackball on the Remote
Control unit to position the cursor.
C.
Normally you can control the slides in the presentation with the Remote Control's
u
"NEXT,
PREV", "R" or "L" buttons.
D.
In the Remote Programmer Utility there are pre-defined key templates for some of the
more common presentation software packages. To use a pre-defined key template select
the FILE pull down menu, then select OPEN, this will display a list of the key templates.
Highlight the template for the presentation package you are using and click OK. This
will assign the presentation functions to the five function keys on the Remote Control
unit.
E.
For special programs, the user has the ability to reassign any of the five function keys to
perform specialized tasks. Refer to the user guide for reassigning the function of keys
with Key Help and Record mode.
function buttons are labeled 'L", "R", DRAG, PREV, and NEXT
Page 3 of 4