Epson 745c - PowerLite XGA LCD Projector Посібник - Сторінка 10

Друкувати сторінку

Epson 745c - PowerLite XGA LCD Projector Посібник

Epson PowerLite 745c Projector

6. Press

to close the Password Protect menu.

Starting the Projector with a Password

Caution:

If you lose the remote control, you will not be able to enter the

password; so keep the remote control in a safe place at all times.

When the password function is enabled, you see this screen

when you turn on the projector:

Hold down the

button on the remote control as you use

Num

the numeric keypad buttons to enter the password. Once you

have entered the password correctly, the password screen closes,

and projection begins.

If the password is not correct, you see the message

password. Please try again

password three times in succession, you see the message

projector's operation will be locked. Request code xxxxx

and the projector switches to standby mode for approximately 5

minutes. Write down the request code. Then disconnect the

projector's power cord from the electrical outlet, reconnect it,

and turn the projector back on. When you see the Password

Protect Release screen, enter the correct password.

If you have forgotten the password, contact Epson for assistance

and give them the request code number that appears in the

Password Protect Release screen.

If you enter an incorrect password 30 times in a row, the

projector remains locked and you must contact an authorized

Epson servicer to unlock it.

Epson PowerLite 745c Projector

Wrong

. If you enter an incorrect

Disabling the Projector's Buttons

When you enable the Operation Lock function, all the

projector's buttons are disabled except the P

This is useful, for example, if you want to prevent students in a

classroom from playing with the projector.

1. Press the

2. Select the

3. Select

Operation Lock

4. Select

to confirm the setting.

5. Press the

Note:

You can cancel Operation Lock by pressing the projector's

button for 7 seconds.

Presenting Over a Wireless Network

Using EMP NS Connection, you can project images shown

on your computer screen directly to your audience without

connecting the projector to your computer. Before you begin,

The

make sure you've installed EMP NS Connection from the

CD-ROM that came with your projector. See the User's Guide

for installation instructions.

Starting EasyMP

Before you can connect to the projector wirelessly, you have to

switch it to EasyMP mode.

1. Turn on the remote control and the projector. Press the

EasyMP

the source.

2. Locate the Epson 802.11G/B card that came with your

projector. Insert it with the label facing upward.

Note:

Only the Epson 802.11G/B card is guaranteed to work.

Other cards may not be compatible.

8/04

button.

menu and press

Setting

Enter

and press

Enter

and press

. Then select

Enter

button to exit the menu system.

™

button on the remote control to select EasyMP as

button.

Power

and press

Yes

Enter