Siemens TSM-1 Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Блок управління Siemens TSM-1. Siemens TSM-1 4 сторінки. Test switch module

Друкувати сторінку

Installation Instructions

MODEL TSM-1

Test Switch Module

INTRODUCTION

The Model TSM-1 Test Switch Module from Siemens

Building Technoliges, Inc. is a key activated momen-

tary switch for use with intelligent duct detectors on

the MXL System. It is used in conjunction with a TRI,

whose CSG-M usage is set to TEST. When the TRI

senses the TSM-1 switch closure, it will cause its

associated intelligent duct detector to go into alarm.

This alarm condition will cause all logic associated

with the duct detector to activate. The TSM-1 is

mounted on a switch plate and can be installed in a

single gang box.

Remove all power from the system until the

installation is complete and ready for testing.

All work of any kind shall be performed to meet

the requirements of all local and national codes

and/or standards required by the authority hav-

ing jurisdiction.

WIRING INSTRUCTIONS

Refer to the wiring diagrams in Figures 2 and 3

and wire the addressable interface module

according to the appropriate operation for your

system.

Note: The recommended wire size is as follows:

18 AWG minimum

14 AWG maximum

Siemens Building Technologies, Inc.

8 Fernwood Road

Florham Park, New Jersey 07932

P/N 315-098285-8

POWER LIMITED WIRING FOR THE TSM-1

TEST SWITCH MODULE

In compliance with NFPA 70—National Electrical

Code, all power limited fire protective signaling

conductors must be separated by a minimum of ¼

inch from all of the following items located within an

outlet box:

• Electric light

• Power

• Class 1 or non-power limited fire protective

signaling conductors

INSTALLATION

1. Remove the module from its protective bag.

Mount the TSM-1 in a user supplied standard

single gang mounting box (1½ in deep is

recommended). Refer to Figure 1.

2. Terminate all field wires to the TSM-1 as required

for your application. Refer to the connection

diagrams shown in Figures 2 and 3.

3. Attach the switch frame to the box.

4. Check that jumper JP1 is NOT installed. (JP1 is

not used in this application.)

5. Attach the keyswitch connector to its mating plug

on the bottom of the circuit board.

6. Insert the face plate and attach the cover plate

with the two screws provided.

Note: A yellow and green LED are included in the

kit. Do not use them in this application.

Siemens Building Technologies, Ltd.

2185 Derry Road West

Mississauga, Ontario L5N 7A6 Canada

Fire Safety