Siemens Washing machine Посібник з експлуатації та інструкція з монтажу - Сторінка 25

Друкувати сторінку

Siemens Washing machine Посібник з експлуатації та інструкція з монтажу

What to do if...

If a malfunction can not be remedied with the assistance of the following charts

•Turn programme selector to "Off".

• Disconnect washing machines from mains.

• Turn off tap.

Danger of electric shock!

Have repairs carried out only through the service department or by authorised specialists.

Problem

The programme does

not start

Severe vibrations during

the spin cycle

The laundry was not or

was insufficiently spun

dry

Water runs out from the

appliance

The machine does not

drain out

The lid does not open

The drum lid opens too

slowly

Depending upon the model.

Possible cause / Remedial action

• The selection of the programme was not fully completed:

- The "Start/Pause" button has not been pressed.

- Programme selector remains in the Stop position.

• The washing machine is not supplied with power:

- Check if the mains cable is connected.

- Check protection devices.

• The tap is closed.

• The inlet hose is torn

• The lid is not properly closed.

• The transportation protection devices for the appliance have not been

completely removed:

- Check if all the transportation protection devices were removed.

(see chapter "REMOVING THE TRANSPORTATION PROTECTION

DEVICES")

• The floor is not level.

• The appliance rests on the two "front" castors (depending upon

model).

- Push the locking lever towards the right.

• You have chosen a programme without a spin cycle, i.e. "Gentle Spin".

• The imbalance control system has detected an improper distribution

of laundry in the drum:

- Re-sort the laundry and again select "Spin".

• the drain hose is improperly inserted into the drainage line.

• the water-inlet hose leaks at the machine and at the tap:

- Check the gaskets and connections.

• "Rinse Stop" was chosen.

• The drain pump filter is blocked:

- clean the filter (see chapter "CLEANING THE FILTER" )

• The drain hose is broken or crimped.

• The programme has not yet ended.

The lid remains locked during the entire time of the programme.

• The washing machine has not been used for a long time.

• The washing machine is in a room that is too cold.

• Residual detergent (powder) is blocking the hinges.

- Remove residual detergent.