Individual settings
Options buttons
The spin speed and temperature can be changed before and during the selected programme. The effects depend on
the programme progress.
Temp. (Temperature)
You can change the displayed washing temperature. The maximum washing temperature that can be selected
depends on the programme that has been set.
rpm (Spin speed) /
(Rinse hold = no final spin)
You can change the spin speed shown or select
last rinse, - - - appears in the display panel). You can change the spin speed shown. The maximum selectable spin
speed depends on the model and on which programme is currently selected.
Finish in
When you select the programme, the relevant progr. duration is displayed. You can delay the start of the programme be-
fore it begins. The "Finished in" time can be set in increments of one hour up to a max. of 24 hours. Press the Finish in
button repeatedly until the desired number of hours is displayed (h = hour). Press Start/Reload.
Additional functions
and overview of programmes, page 7
speed Perfect For washing in a shorter time with a washing result comparable to that of the standard
programme. Maximum load
eco Perfect
For saving energy with a washing performance comparable to that of the standard programme.
Easy Iron
Special spin sequence with subsequent fluffing. Gentle final spin at reduced speed.
Residual moisture in the laundry is increased slightly.
Extra Rinse
Additional rinse cycle. For areas with very soft water or for further enhancing the washing result.
Childlock
You can lock the washing machine to prevent the functions you have set from being changed
in the display panel
inadvertently.
ON/OFF: after the start/end of the programme, press and hold Start/Reload for approx.
5 seconds.
Note: The childlock can remain activated until you wish to start the next programme, even after
switching off the machine.
Then you can deactivate the childlock before starting the programme and activate it again as
necessary once the programme has started.
Note:
– The
symbol is lit: Childlock active.
– The
symbol flashes: Childlock active and then the programme selector is altered.
To prevent the programme from stopping, move the programme selector back to the original
programme, the
Add laundry
+
If you want to add additional items of laundry after the programme has started, press the
Start/Reload button. The machine checks whether adding laundry is possible.
in the display panel
+
are lit: Adding laundry is possible.
flashing: Wait until
Note: Only open the washing machine door when both the
: It is not possible to add laundry.
Note: for safety reasons, the washing machine door remains locked when the water level
and/or temperature is high, or during spinning.
To continue the programme, press the Start/Reload button.
Energy saving mode
If the washing machine is switched on and is not operated for several minutes before the programme starts or
at the end of the programme, the display panel light goes out and the Start/Reload button flashes.
Press any button to turn the light back on.
(Rinse hold = no final spin, laundry remains in the water after the
Overview of programmes, page 7.
symbol is lit again.
+
are lit.
+
symbols are lit.
Individual settings
Signal
1. Activating the
mode for setting the
signal volume
Set to
Button signals
2. Set the volume
for ...
* you may need to select
Set the
the function several
volume*
times.
Start/Reload
To start the programme or to subsequently load additional laundry, and to activate/deactivate the childlock.
5
+
1 step, the
Press and
1 step, release
display panel
hold
lights up
Information signals
skip
1 step
Set the
volume*
Set to
6
Друкувати сторінку