Siemens WM N Series Посібник - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник для Пральна машина Siemens WM N Series. Siemens WM N Series 44 сторінки.

Друкувати сторінку
Positioning and connecting
en
Do not alter (shorten, cut through)
■
the water supply hose (otherwise, its
strength is no longer guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
When connecting to a 21 mm = ½"
■
tap, first fit an adapter
washer from 21 mm = ½" to 26.4
mm = ¾".
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
Model: Standard
■
*
supplied depending on the model
16
*
with a sealing
www.devicemanuals.eu/
Model: Aqua­Secure
■
Model: Aqua-Stop
■
Open the water tap carefully,
Note:
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.

Water outlet

Caution!
Water damage
If the drain hose slips out of the
washbasin or the connection point
during draining due to high water
pressure, any escaping water may
cause water damage.
Secure the drain hose so that it cannot
slip out.
Notes
Do not kink the water drain hose or
■
put strain on it lengthways.
Height difference between the
■
installation surface and the drain:
min. 60 cm, max. 100 cm
You can lay the water drain hose as
follows:
Outlet in a sink
■