Siemens WM..T SERIES Посібник з експлуатації та інструкція з монтажу - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник з експлуатації та інструкція з монтажу для Пральна машина Siemens WM..T SERIES. Siemens WM..T SERIES 40 сторінок.

Друкувати сторінку

Additional programme settings

out of the washing machine immediately

after the program has ended.

To continue/end the program

~ Page 27

The maximum speed that can be set

depends on the model and program

that has been selected.

Finished in-time

(û, û Finish in, û Ready in)

Before starting the program, you can

preselect the program end ("Ready in"

time) in hourly increments (h = hour) up

to a maximum of 24 hours.

To do this:

Select a program.

The program duration is displayed

for the selected program, e.g. 2:30

(hours:minutes).

Press the Finished in-time button

repeatedly until the required number

of hours is displayed.

Press the ‹ button.

The door will be locked.

The selected number of hours (e.g. 8

h) is shown in the display panel and

counts down until the wash program

starts. The duration of the program is

then displayed.

During the timer count-down, you can

change the preselected number of

hours as follows:

Press the ‹ button.

Use the Finished in-time button to

change the number of hours.

Press the ‹ button.

During the timer count-down, you can

add or remove laundry as required:

Press the ‹ button.

Open the door and add or remove

laundry.

Close the door.

Press the ‹ button.

The length of the program is

Note:

automatically adjusted when the

program is running.

Certain factors can affect the program

length, e.g.:

Program settings,

■

Detergent dosage (additional rinse

■

cycles if required due to foaming),

Load size/type of textiles (longer

■

washing for higher load and for

textiles which absorb more water),

Imbalances (e. g. due to fitted

■

sheets) are offset with several start-

ups of spin cycles,

Fluctuations in power supply,

■

Water pressure (infeeding speed).

■

Additional programme

settings

You can find an overview of all possible

A d d i t i o n a l p r o g r a m m e s e t t i n g s

additional settings on the

supplementary sheet for the installation

and operating instructions.

The settings vary depending on the

model.

speed eco

(( ¦, ( speedPerfect, ¦ ecoPerfect)

Button with two possible settings for

adapting the selected program:

speed (()

■

Washing in a shorter time while

achieving a washing result that is

consistent with, but uses more

energy than the selected program

without the speed setting.

Do not exceed the maximum

Note:

load.