•
If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets on your hands, wash them
immediately.
•
Replace the batteries as soon as they run out.
•
Remove the batteries if you will not be using the system for a long period of time.
•
Do not expose batteries to heat or flame and do not put them in water.
•
Dispose of used batteries according to local regulations.
•
Keep these batteries out of the reach of children. Batteries are choking hazards and are very dangerous if
swallowed.
Consult your state and local regulations regarding proper disposal of batteries.
•
Never loosen any bolts, screws, or nuts after installation. Periodically check to make sure that none of them
have come loose. If you find loose hardware, retighten it firmly.
•
Before moving the system, be sure to check that the power is turned off, the plug is disconnected from the
outlet, and all cables are disconnected. Fire or electric shock may result.
•
Do not place any heavy objects on the system or stand on it. It may tip over and cause injury or damage to
the system.
•
Do not use or store the system where the temperature is too high or too low. Avoid places where the
temperature changes frequently and rapidly.
Additional Safety Instructions
•
Safety measures must be practiced at all times during the installation of this product. Proper installation
procedures, as outlined in these instructions, must be adhered to. Failure to do so could result in serious
personal injury or death.
•
This product should be installed by a professional audio/video installer or other qualified professional.
Epson cannot provide advice concerning construction practices or building codes in your area.
•
Prior to installing this product, read the installation instructions completely. Keep these instructions in an
easily accessible place for future reference.
•
Do not attempt to install this product if you have any doubts as to its proper assembly and installation.
•
Use proper equipment to prevent personal injury or property damage, such as a ladder for reaching high
places or a stud finder to locate the center of studs.
•
The included mounting hardware is intended for use with a 1.5-inch pipe mount.
•
Do not attempt to use hollow-wall anchors, screws, or similar mounting hardware to mount this product to
wallboard or plasterboard. This product cannot be safely mounted like that. You must mount this product
with the included 1.5-inch mounting pipe, as outlined in these instructions.
•
The ceiling structure on which this product is mounted must be capable of safely supporting the weight of
this product (approximately 15.2 lbs [6.9 kg]) and the weight of your projector. If the structures cannot
support these weights, they must be reinforced.
•
When mounting the equipment on a ceiling that contains studs or joists, the exact center of the studs or
joists must be confirmed prior to installation.
6
Друкувати сторінку