Epson AP-60 - Projector Sound Solution Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу для Проектор Epson AP-60 - Projector Sound Solution. Epson AP-60 - Projector Sound Solution 28 сторінок. Projector sound solution
Також для Epson AP-60 - Projector Sound Solution: Посібник користувача (28 сторінок), Посібник (5 сторінок), Посібник з підключення (1 сторінок), Перелік деталей (1 сторінок), Брошура та технічні характеристики (4 сторінок), Бюлетень підтримки продукту (8 сторінок)

Introduction

Before installing the AP-60, you should perform the following steps:

•

Run all wiring required for the audio and power connections for the AP-60 and projector.

•

If you have a projector already installed, remove the projector from the 1.5-inch mounting pipe and remove

the old mounting pipe. If you aren't installing a projector with the AP-60, make sure you have a ceiling

mount compatible with a 1.5-inch NPT mounting pipe installed.

Parts List

Before starting, make sure you have all the parts listed below. If you're missing any parts, contact Epson as

described on page 26.

AP-60

Lower bracket

Mounting pipe

Note

The included installation hardware is designed for a 1.5-inch pipe mount. You may need additional hardware if your setup

varies.

You can purchase projectors, screens, or other accessories from an Epson authorized reseller. To find the nearest

reseller, call 800-GO-EPSON (800-463-7766). Or you can purchase online at www.epsonstore.com (U.S. sales)

or www.epson.ca (Canadian sales).

To order an additional pendant microphone, request part number V12H3290M1.

Pendant microphone

Power cable

M10 bolt and nut

M47.5 jam nut

Neck strap

Remote control

Guy wires

IR dome sensor

LR6 (alkaline)

AA batteries

R6 (manganese)

AA batteries

Coaxial cable