Cisco 7931G - Unified IP Phone VoIP Посібник - Сторінка 27

Переглянути онлайн або завантажити pdf Посібник для IP-телефон Cisco 7931G - Unified IP Phone VoIP. Cisco 7931G - Unified IP Phone VoIP 30 сторінок. For cisco unified callmanager express 4.0
Також для Cisco 7931G - Unified IP Phone VoIP: Посібник користувача (20 сторінок), Посібник з адміністрування (10 сторінок), Посібник з адміністрування (17 сторінок), Посібник з адміністрування (20 сторінок), Інструкція з монтажу (4 сторінок), Посібник з адміністрування (12 сторінок), Короткий довідник (2 сторінок), Коротка довідкова картка (2 сторінок), Посібник користувача (15 сторінок)

Cisco Unified IP Phone 7931G

If you used autoregistration, update the specific configuration information for the phone: associate the phone

with a user, change the button table, or assign a directory number.

Install Cisco Unified IP Phone 7931G

The following steps provide an overview and checklist of installation tasks for the Cisco Unified IP Phone

7931G. The steps present a suggested order to guide you through the phone installation. Some tasks are

optional, depending on your system and user needs. For detailed procedures and information, refer to the

sources in the steps.

Procedure

Step 1

Choose the power source for the phone:

• Power over Ethernet (PoE)

• External power supply

Determines how the phone receives power.

Step 2

Assemble the phone, adjust phone placement, and connect the network cable.

Locates and installs the phone in the network.

Step 3

Monitor the phone startup process. Verifies that phone is configured properly.

Step 4

If you are configuring the network settings on the phone for an IPv4 network, you can set up an IP address

for the phone by either using DHCP or manually entering an IP address.

a) Using DHCP: To enable DHCP and allow the DHCP server to automatically assign an IP address to the

Cisco Unified IP Phone and direct the phone to a TFTP server, choose Settings > Network Configuration

> IPv4 Configuration and:

• To enable DHCP, set DHCP Enabled to Yes. DHCP is enabled by default.

• To use an alternate TFTP server, set Alternate TFTP Server to Yes, and enter the IP address for the

Note

b) Without DHCP: You must configure the IP address, subnet mask, TFTP server, and default router locally

on the phone, choose Settings > Network Configuration > IPv4 Configuration:

To disable DHCP and manually set an IP address:

1 To disable DHCP, set DHCP Enabled to No.

2 Enter the static IP address for phone.

3 Enter the subnet mask.

4 Enter the default router IP addresses.

5 Set Alternate TFTP Server to Yes, and enter the IP address for TFTP Server 1.

You must also enter the domain name where the phone resides by choosing Settings > Network

Configuration.

TFTP Server.

Consult with the network administrator if you need to assign an alternative TFTP server instead

of using the TFTP server assigned by DHCP.

Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)

Cisco Unified IP Phone Installation