Siemens dishwasher Інструкція з використання Посібник з використання - Сторінка 22

Друкувати сторінку

Siemens dishwasher Інструкція з використання Посібник з використання

aus

Delivery

Your dishwasher has been checked

thoroughly in the factory to ensure that it

is in working order. This may cause small

water stains. These will disappear after the

first wash cycle.

Installation

The required installation dimensions can

be found in the installation instructions.

Level the appliance with the aid of the

height-adjustable feet. Ensure that the

appliance is situated securely on the floor.

A built-under or integrated appliance

which is installed subsequently as

a free-standing appliance must be

secured to prevent it from overturning,

e.g. by screwing it to the wall or by

installing it under a continuous worktop

which is screwed to adjacent

cupboards.

The appliance can easily be installed

in a fitted kitchen between wooden and

plastic walls. If the plug is not freely

accessible following installation,

an allpole disconnector with a contact

opening of at least 3 mm must be fitted

on the installation side to satisfy the

relevant safety regulations.

Waste-water connection

The required work sequence can be

found in the installation instructions.

If required, fit a siphon with an drainage

connection.

Connect the waste-water hose to the

drainage connection of the siphon with

the enclosed parts.

Ensure that the drainage hose is not

kinked, crushed or twisted and that

there is no cover plate in the drainage

to prevent the waste water from flowing

out!

Fresh-water connection

Connect the fresh-water connection

to the tap according to the installation

instructions with the enclosed parts.

Ensure that the fresh-water connection

is not kinked, crushed or twisted.

When replacing the appliance,

always use a new water supply hose.

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing

valve ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

We recommend cold water connection

only.

Electrical connection

Connect the appliance to an alternating

current only, ranging from 220 V to

240 V and 50 Hz or 60 Hz via a correctly

installed socket with protective earth

conductor. See rating plate for required

fusing

The socket must be near the appliance

and freely accessible following

installation.

The connection may be modified

by technicians only.

A power cord extension may be

purchased from customer service only.

Use only a residual-current-operated

circuit-breaker which features the

symbol. Only this extension guarantees

compliance with the currently valid

regulations.

The appliance features a water damage

protection system. Please note the

system will function only when the

power supply is connected.