Siemens dishwasher Інструкція з експлуатації Посібник з експлуатації - Сторінка 21

Друкувати сторінку

Siemens dishwasher Інструкція з експлуатації Посібник з експлуатації

Fresh water connection

– Connect the fresh-water connection to

the tap according to the installation

instructions with the enclosed parts.

Ensure that the fresh-water connection

is not kinked, crushed or twisted.

– When replacing the appliance, always

use a new water supply hose.

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing valve

ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

for cold water connection only.

Electrical connection

– Connect the appliance to an

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See rating

plate for required fusing 9*.

– The socket must be near the appliance

and freely accessible following

installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side to satisfy

the relevant safety instructions.

– The connection may be modified by

technicians only.

– A power cord extension may be

purchased from customer service only.

– Use only a residual current operated

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

– The appliance features a water

damage protection system. Please

note the system will not function

unless the power supply is connected.

Removing the appliance

Also observe the sequence of worksteps

here.

– Disconnect the appliance from

the power supply.

– Turn off the water supply.

– Disconnect the waste water and fresh

water connections.

– Loosen fastening screws for the

furniture parts.

– If fitted, remove the base panel.

– Pull out the appliance, carefully pulling

the hose behind.

Transportation

Empty the dishwasher and secure loose

parts.

Drain the appliance according to the

following steps:

– Turn on the tap.

– Close the door.

– Switch on ON/OFF switch (. The

displays of the last selected

programme light up.

– Select programme with the highest

temperature.

The expected programme duration is

indicated on the numerical display

)".

– Press START button `.

Programme sequence starts.

– After approx. 4 minutes press the

START button ` until :

indicated on the digital display.

After approx. 1 min :

on the digital display .

– Switch the appliance off ( and turn

the tap off.

Transport appliance upright only.

(This prevents residual water from running

into the machine control and damaging

the programme sequence.)

aus

is indicated