Siemens SX Series Інструкція з експлуатації Посібник з експлуатації - Сторінка 24

Друкувати сторінку

Siemens SX Series Інструкція з експлуатації Посібник з експлуатації

Operating the appliance

Switching on the appliance

1. Turn on the tap fully.

2. Open the door.

3. Switch on ON/OFF switch (.

The Eco 50° programme display

flashes. This programme remains

selected if no other programme

button 0 is pressed. The expected

programme duration

flashes on the digital display h.

4. Press the START button `.

5. Close the door.

The programme starts running.

Note

- for environmentally friendly operation

of the dishwasher:

For ecological reasons the Eco 50°

programme is preset whenever the

appliance starts. This conserves

environmental resources and not least

saves you money.

The Eco 50° programme is a

particularly environmentally friendly

programme. According to EU

regulation 1016/2010 it is the

"Standard programme" which is the

most efficient standard cleaning cycle

for cleaning normally soiled utensils in

terms of the combined energy and

water consumption for cleaning these

types of utensils.

O ptical display while

O p t i c a l d i s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g

the programme is running *

* depending on model

While the programme is running, a light

spot shines on the floor under

the appliance door. Do not open

the dishwasher door until the light point

is no longer visible on the floor.

If the door is not completely closed, the

light spot flashes. *

If the appliance is installed at eye-level,

with flush furniture front, the light point

is not visible.

This function can be changed as

follows:

1. Open the door.

2. Switch on ON/OFF switch (.

3. Hold down programme button #

and press START button ` until

•:‹.... is indicated on the digital

display.

4. Release both buttons.

The LED for button # flashes

and the digital display h displays

the factory setting •:‹....

5. Press programme button # until

the factory set value ‚:‹‚

is indicated on the digital

display h.

To change the setting:

1. By pressing the button 3, you can

switch the function off ‚:‹‹

or on ‚:‹‚.

2. Press START button `.

The set value is saved.

3. Close the door.