Siemens EG6B.H Series Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Siemens EG6B.H Series. Siemens EG6B.H Series 12 сторінок.
Також для Siemens EG6B.H Series: Інструкція з експлуатації (12 сторінок)
Друкувати сторінку
Gas burners
en
Accessories
The following accessories can be purchased from the
Technical Assistance Service:
--------
Code
HZ298108 Additional wok grid: cast iron (3.3 kW)
HZ298110 Additional wok grid: Enamelled steel
HZ298114 Additional espresso maker grid
HZ298105 Simmer Plate
HZ298104 Simmer cap
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
6
Additional wok grid
Only suitable for use on wok
burners. Use cookware with a
rounded base.
To extend the service life of the
appliance, we recommend using
the additional wok grid.
Additional espresso maker
grid
Only suitable for use on the
smallest burner. Use cookware
with a diameter of less than
12 cm.
Simmer plate
This accessory part is only suita-
ble for simmering. It can be
used with the economy burner
or the standard-output burner. If
your hob has several standard-
output burners, we recommend
placing the simmer plate on the
rear or front-right standard-out-
put burner.
Place the accessory component
with the projections facing
upwards on the holder; never
place it directly on the burner.
Simmer cap
Only use the burner for cooking
with minimal power. Remove
the economy burner and
replace it with the simmer cap.
Always place cookware on the
pan support, never directly on
the simmer cap.
ÄGas burners
S witching on manually
G a s b u r n e r s
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power setting.
Hold an igniter or a naked flame (such as a lighter or
2.
a match) against the burner.
Automatic ignition
If the hob has automatic ignition (ignition plugs):
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power level.
While the control knob is held down, all the burners
will generate sparks. The flame ignites. Wait a few
seconds.
Release the control knob.
2.
Turn the control knob to the required position.
3.
If the burner does not ignite, switch it off and repeat the
steps described above. This time, hold the control knob
down for longer (up to 10 seconds).
:
Warning – Risk of deflagration!
If the flame does not ignite after 15 seconds, switch off
the burner and open a window or the door to the room.
Wait at least one minute before switching the burner on
again.
It is important to keep the appliance clean. If the
Note:
ignition plugs are dirty, this may cause ignition
problems. Clean the ignition plugs regularly with a
small, non-metallic brush. Take care to prevent the
ignition plugs from suffering any heavy knocks.
Safety system
Your hob is equipped with a safety system
(thermocouple) that cuts off the gas when the burners
are accidentally switched off.
To ensure that this device is active:
Switch on the burner as usual.
1.
Without releasing the control knob, press and hold it
2.
down firmly for 4 seconds after lighting the flame.
Switching off a burner
Turn the corresponding control knob clockwise to the 0
setting.
A few seconds after the burner is switched off, a sound
(thud) will be produced. This is not a fault - this means
that the safety device is no longer operating.
Warnings
It is normal to hear a soft whistling noise while the
burner is operating.
When first used, it is normal for the burner to give off
odours. This does not pose any risk and does not
indicate a malfunction. They will disappear in time.