Siemens EH BE Series Інструкція з експлуатації - Сторінка 16
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Siemens EH BE Series. Siemens EH BE Series 24 сторінки.
Також для Siemens EH BE Series: Інформація для використання (16 сторінок)
Друкувати сторінку
Cookware check
en
To access the basic settings:
The hob must be off.
Switch on the hob.
1.
Within ten seconds, touch and hold the
2.
for approximately four seconds.
The first four displays provide product information.
Touch the
or
symbol to view the individual
@
A
displays.
Product information
After-sales service index (ASSI)
Production number
Production number 1
Production number 2
Touch the
symbol again to access the basic
1
3.
settings.
and
flash alternately on the displays and
™
‚
appears as a presetting.
Touch the
symbol repeatedly until the required
1
4.
function is displayed.
Then use the
and
@
5.
required setting.
Touch the
1
symbol for at least four seconds.
6.
The settings have been saved.
Leaving the basic settings
Turn off the hob with the main switch.
16
symbol
1
Display screen
‹‚
"š
Š†
.
‹
.
†
symbols to select the
A
tCookware check
T his function can be used to check the speed and
C o o k w a r e c h e c k
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
Place the cold cookware containing 200 ml of water
1.
on the centre of the hotplate the diameter of which
best matches that of the base of the cookware.
Go to the basic settings and select the setting
2.
Touch the
3.
display.
The function is activated.
After 10 seconds, the result for the quality and speed of
the cooking process appears in the hotplate display.
‹
Check the result using the following table:
Result
The cookware is not suitable for the hotplate and will therefore
‹
not heat up.*
The cookware is taking longer to heat up than expected and the
‚
cooking process is not going as well as it should.*
The cookware is heating up correctly and the cooking process
ƒ
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.
To activate the function again, select the
Notes
If the diameter of the hotplate used is much smaller
■
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
■
section on ~ "Basic settings".
You can find information on the type, size and
■
positioning of the cookware in the section on
~ "Induction cooking".
or
symbol.
flashes in the hotplate
@
A
A
.
™‚ ƒ
or
symbol.
@
A