Siemens EH611BE15E Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Siemens EH611BE15E. Siemens EH611BE15E 28 сторінок. Induction hob with integrated ventilation system
Друкувати сторінку
en Checking the cookware
Use
or
to select the required setting.
5.
15
Checking the cookware
You can use this function to check the speed and qual-
ity of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the cooking zone being
used.
You can find more information about this function un-
der
→ "Basic settings", Page 15 and on the type, size and
positioning of the cookware under
→ "Induction cooking", Page 7.
15.1 Procedure for checking the cookware
Fill the cookware with approximately 200 ml water
1.
and place it at room temperature in the middle of
the cooking zone that most closely matches the dia-
meter of the base of the cookware.
Call up the basic settings and select .
2.
Touch or . The
3.
zones.
a The function has been activated.
a After 10 seconds, the result appears in the cooking
zone displays.
16
PowerManager function
You can use the PowerManager function to set the total
power of the hob.
The hob is set at the factory; the hob's maximum power
is shown on the rating plate. You can use this function
to adjust the configuration to the requirements of each
electrical installation.
16
display flashes in the cooking
Touch and hold
6.
a The settings are saved.
14.3 Exiting the basic settings
Touch
to switch off the hob.
▶
Note: If the diameter of the cooking zone that is used
is much smaller than the diameter of the cookware,
only the middle of the cookware can be expected to
heat up. This may result in the cooking results not be-
ing as good as expected or being less than satisfact-
ory.
15.2 Checking the result
In the following table, you can check the result for the
quality and speed of the cooking process:
Result
The cookware is not suitable for the
cooking zone and therefore does not
heat up.
The cookware is taking longer to heat
up than expected and cooking is not
progressing as well as it ought to.
The cookware is heating up correctly
and cooking is progressing well.
1
If a smaller cooking zone is available, test the cook-
ware on this cooking zone.
Touch or
to activate the function.
In order to not exceed this set value, the hob automat-
ically distributes the available power as needed
between the cooking zones that are switched on.
While the PowerManager function is activated, the out-
put of a cooking zone may temporarily fall below the
nominal value. In order to not exceed this set value, the
for four seconds.
1
1